Acura TSX / Honda Accord CL. Manual — part 710
DRIVE BELT ROUTING
Information not available from manufacturer.
ENGINE COOLING
SERVICE
Cooling System Specifications
COOLING SYSTEM SPECIFICATIONS
FUEL SYSTEM
FUEL PRESSURE
Fuel Pressure Specifications
FUEL PRESSURE SPECIFICATION
IDLE SPEED
IDLE SPEED SPECIFICATION
IGNITION SYSTEM
FIRING ORDER
Model
Specification
Coolant Replacement Interval
120,000 Miles
(1)
Coolant Capacity
A/T
5.6 Qts. 5.3 L)
M/T
5.7 Qts. (5.4 L)
Pressure Cap Opens
14-18 psi (93-123 kPa)
Thermostat Opens
Starts
169-176° F (76-80° C)
Fully Open
194° F (90° C)
(1)
Replace after 10 years.
Condition
Specification
At Idle
48-55 psi (3.4-3.9 kg/cm
2
)
Condition
Specification
Transmission
A/T
750-850 RPM
M/T
700-800 RPM
2004 Acura TSX
2004 SPECIFICATIONS TSX
Illustrations
To identify firing order, see Fig. 3 .
Fig. 3: Firing Order
Courtesy of AMERICAN HONDA MOTOR CO., INC.
IGNITION TIMING
Check ignition timing in no-load condition (headlights, blower fan, rear defogger and A/C off) with M/T in
Neutral or A/T in Neutral or Park. Connect scan tool to 16-pin Data Link Connector (DLC) before checking
timing. Ensure idle speed and ignition timing are set to 6-10° BTDC (Red mark). See IDLE SPEED
SPECIFICATION table. For timing mark identification, refer to illustration. See Fig. 4 .
2004 Acura TSX
2004 SPECIFICATIONS TSX
Fig. 4: Identifying Ignition Timing Mark
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 SPECIFICATIONS TSX
SPARK PLUGS
All Specifications
SPARK PLUG TYPE
SPARK PLUG SPECIFICATIONS
STARTING SYSTEM
STARTER
Starting System Service Specifications
CRANKING TEST SPECIFICATIONS
STARTER NO-LOAD TEST SPECIFICATIONS
STARTER PERFORMANCE TEST SPECIFICATIONS
STARTER SPECIFICATIONS
Application
Specification
Nippondenso
SKJ20DR-M11
NGK
IZFR6K-11
Application
Specification
Standard (NEW) Gap
(1)
.039-.043 In. (1.0-1.1 mm)
Torque
13 Ft. lbs. (18 N.m)
(1)
DO NOT adjust gap on platinum spark plugs. If adjustment is required, replace with NEW platinum
spark plug.
Minimum Cranking Volts
Maximum Current Draw (Amps)
8.5
380
Maximum Amps
Minimum RPM
80
2600
Application
(1)
Maximum Amps @ Minimum RPM
Starter
80 @ 2300
(1)
Battery voltage must stay at 11.5 volts or more during test.
Application
Specification
Brush Length
Standard
.44 -.45" (11.1- 11.5 mm)
Minimum
.17" (4.3 mm)
Commutator Diameter
Standard
1.102-1.106" (28.0-28.1 mm)
2004 Acura TSX
2004 SPECIFICATIONS TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст