Acura TSX / Honda Accord CL. Manual — part 715
increased wear and poor steering in cold weather.
System Capacity: 1.1 L (1.16 US. qt) at disassembly
Reservoir Capacity: 0.4 L (0.42 US. qt)
Fig. 13: Identifying Reservoir
1. Raise the reservoir, then disconnect the return hose (A) to drain the reservoir. Take care not to spill the
fluid on the body and parts. Wipe off and spilled fluid at once.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 14: Draining The Reservoir
2. Connect a hose (B) of suitable diameter to the disconnected return hose, and put the hose end in a suitable
container.
3. Start the engine, let it run at idle, and turn the steering wheel from lock-to-lock several times. When fluid
stops running out of the hose, shut off the engine. Discard the fluid.
4. Reinstall the return hose on the reservoir.
5. Fill the reservoir to the upper level line (C).
6. Start the engine and run it at fast idle, then turn the steering from lock-to-lock several times to bleed air
from the system.
7. Recheck the fluid level and add more if necessary. Do not fill the reservoir beyond the upper level line.
8. If the fluid is contaminated, dark, or discolored, repeat procedure as necessary.
POWER STEERING HOSE, LINE & PRESSURE SWITCH REPLACEMENT
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Note these items during installation:
z
Connect each hose to the corresponding line securely until it contacts the stop on the line. Install the
clamp or adjustable clamp at the specified distance from the hose end as shown.
z
Check all clamps for deterioration or deformation; replace with the clamps NEW ones if necessary.
z
Add the recommended power steering fluid to the specified level on the reservoir and check for leaks.
Fig. 15: Replacing Power Steering Hose, Line, And/Or Pressure Switch
PUMP REPLACEMENT
1. Place a suitable container under the vehicle.
2. Drain the power steering fluid from the reservoir.
3. Remove the drive belt (A) from the pump pulley (see DRIVE BELT ).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 16: Removing Pump
4. Remove the pump mounting bolts (B).
5. Cover the auto-tensioner, alternator, and A/C compressor with several shop towels to protect them from
spilled power steering fluid. Disconnect the pump inlet hose (C) and jump outlet hose (D) from the pump
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст