Acura TSX / Honda Accord CL. Manual — part 237
1. Lower the door glass fully.
2. Carefully pry out the mirror mount cover (A) by hand in the sequence shown.
Fig. 2: Prying Out The Mirror Mount Cover
3. Remove the door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
4. Remove the plastic cover as necessary, then detach the harness clip (A), and disconnect the connector
(B). While holding the mirror (C), remove the nuts.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX
Fig. 3: Disconnecting The Connector
5. Remove the mirror (A). Take care not to scratch the door.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX
Fig. 4: Removing The Mirror
6. Install the mirror in the reverse order of removal, and make sure the connector is plugged in properly.
MIRROR HOLDER REPLACEMENT
1. Carefully pull out the bottom edge of the mirror holder (A) by hand. Take care not to scratch the mirror.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX
Fig. 5: Pulling Out The Mirror Holder
2. Separate the mirror holder from the actuator (B) by slowly pulling them apart while removing the
adhesive (C), detaching the clips (D), and releasing the hooks (E, F). If equipped, disconnect the mirror
defogger connectors (G).
3. If equipped, reconnect the mirror defogger connectors.
4. Reattach the hooks of the mirror holder to the actuator, then position the mirror holder on the actuator.
Carefully push on the clip portions of the mirror holder until the mirror holder locks into place.
5. Check the operation of the actuator.
REARVIEW MIRROR REPLACEMENT
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст