Acura TSX / Honda Accord CL. Manual — part 189
Fig. 22: Checking Pressure Control Valve
18. Inspect the ball bearing by rotating the outer race slowly. If you feel any play (axial or radial) or
roughness, remove the faulty ball bearing (A), and install a NEW one (B).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 23: Replacing The Ball Bearing
19. Inspect each part shown with an asterisk in the Exploded View; if any of them are worn or damaged,
replace the pump as an assembly.
Reassembly
2004 Acura TSX
2004 STEERING Power Steering System - TSX
20. Install the NEW pump seal (A) (with its grooved side facing in) into the pump housing (B) by hand first,
then drive it in using the special tools with until there is no step at the top of the pump seal, and the seal is
fully seated in the pump housing.
Fig. 24: Installing The NEW Pump Seal
21. Position the pump drive shaft (A) in the pump housing, then press it in with the appropriate size socket
wrench (B) as shown. Do not apply more than 1,370 N (140 kgf, 308 lbf) of pressure.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 25: Pressing Pump Drive Shaft Into The Pump Housing
22. Install the 40 mm snap ring (C) with its radiused edge facing out.
23. Coat the NEW 23.8 mm O-ring (A) with the power steering fluid, then position it on the bottom (B) of
the pump housing.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст