Acura CSX. Manual — part 662
*01
SNR9ANGJ36100063301FEAT00
SNR9ANGJ36100063301KBAT00
Position
Resistance
23-357
23-357
Voice Control Switch Test
Voice Control Switch Replacement
1. Remove the voice control switch (see page 23-357).
2. Measure the resistance between terminals No. 2
and No. 4 in each switch position according to the
table.
No button pressed
About 10 k
TALK
About 2.9 k
BACK
About 680
3. If the resistance is not as specified, replace the
voice control switch (see page 23-357).
SRS components are located in this area. Review the
SRS component location (see page 24-11).
Also review the precautions and procedures (see page
24-13) in the SRS section before doing repairs or
service.
1. Remove the steering wheel (see page 17-6).
2. Remove the voice control switch (see page 17-7).
3. Install the voice control switch in the reverse order
of removal.
08/08/21 14:17:54 61SNR030_230_0360
01
02
SNR9ANGJ36100040151KDAT00
*01
SNR9ANGJ36100030151KDAT02
23-358
23-358
Navigation System
HFL-Navigation Microphone
Removal/Installation
GPS Antenna Removal/Installation
B
E
D
A
C
B
A
A
B
A
B
1. Remove the front individual map light lens (A).
2. Remove the bolts (B), then disconnect the
connectors, and remove the map lights housing (C).
3. Carefully pry off the moonroof switch (D) from the
map light housing while pressing in on the
retaining tabs (E).
4. From the moonroof switch (A), remove the screw
and microphone (B).
5. Install the microphone in the reverse order of
removal.
1. Remove the navigation unit (see page 23-355).
2. Remove the instrument panel visor (see page
20-98).
3. Remove the wire harness clip (A), screws, and GPS
antenna (B).
4. Install the antenna in the reverse order of removal.
08/08/21 14:18:35 61SNR030_230_0361
*01
SNR9ANGJ14233900000DAAT00
23-359
HandsFreeLink System
Component Location Index
HFL-NAVIGATION MICROPHONE
(Built into the roof console)
HANDSFREELINK
CONTROL UNIT
HFL VOLUME
(Using navigation
unit volume knob)
HFL SWITCH
LEFT FRONT
TWEETER
FRONT PASSENGER’S
DOOR SPEAKER
NAVIGATION UNIT
DRIVER’S DOOR
SPEAKER
RIGHT FRONT
TWEETER
Removal/Installation, page 23-358
Input Test/Replacement, page 23-388
Test, page 23-387
Removal/Installation, page 23-355
08/08/21 14:18:36 61SNR030_230_0362
*01
SNR9ANGJ14233930551BBAT00
How to Check for DTCs with the HDS
23-360
HandsFreeLink System
General Troubleshooting Information
A
NOTE: Check the vehicle battery condition first.
1. Make sure the ignition switch is in LOCK (0).
2. Connect the HDS to the data link connector (DLC) (A) located under the driver’s side of the dashboard.
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle and the HandsFreeLink control unit. If it doesn’t, troubleshoot
the DLC circuit (see page 11-204).
5. Select HandsFreeLink in the BODY ELECTRICAL menu.
6. Select DTCs in the HandsFreeLink menu.
7. Check for DTCs. If any DTCs are indicated, write down the DTCs, then go to the indicated DTC troubleshooting. If
no DTCs are indicated, refer to symptom troubleshooting.
NOTE:
• After troubleshooting, clear the DTCs with the HDS.
• For specific operations, refer to the user’s manual that came with the HDS.
08/08/21 14:18:36 61SNR030_230_0363
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст