Acura CSX. Manual — part 608
*37
*38
−
−
Tire Calibration
23-146
Navigation System
Return
Set
Reset
CCW
CW
Tuning
0.0%
ANG-Disp
0°
Return
Auto Tuning
OFF
Level0
xx.xx%
Set
Study
Tire
Cal. Tuning
Tire
Calibrate
ON
OFF
1. Stationary test: If the VP icon spins in place and the
ANG-Disp value slowly increases or decreases in
value, the yaw rate sensor is defective. Replace the
navigation unit.
2. Road test: Drive the vehicle on a very straight road.
Enter the diagnostic mode, select Yaw rate, and
touch the Tuning button. While driving down a
straight road, the white dots should trace a straight
line across the screen. However, if you are driving
on a straight road, and you notice the dots
constantly dropping down or heading up as you
drive, the navigation unit’s yaw sensor is defective.
You can touch Reset to clear ANG-Disp, and dotted
line.
3. If either test fails, please enter ‘‘Yaw rate sensor
defective’’ for the problem description, on the
‘‘Navigation core return form’’.
As the vehicle moves, the navigation system receives
speed pulses from the ECM/PCM. These pulses are
converted using a conversion factor to a mph speed
that moves the vehicle position (VP) on the map. The
navigation system has an internal tuning function that
generates and refines this factor based on actual
driving. The Level indicates the status of the tuning. At
navigation initialization, it begins at 0, and increases to
10 as the navigation system is used.
• The Auto Tuning is factory set to ON, and should
remain on.
• The Study indicates the tuning status. If it is less than
10, the unit is still calibrating.
• The Tire-Cal. Tuning and Set should not be used. It is
for factory use only.
08/08/21 14:07:33 61SNR030_230_0149
*39
*40
*41
*42
Functional Setup
’06 model
’07-08 models
Log Data
23-147
Functional Setup
Log Data
GPS Send Time
Demo Mode
Mic Level
Solar Angle
Functional Setup
Log Data
GPS Send Time
Demo Mode
Mic Level
Solar Angle
Save Users Memory
Return
Return
Log Data
Log Data
Return
PC Card is not inserted.
Return
Logging VP Data
OFF
ON
OFF
Select the item you want to check.
• Log Data
• GPS Send Time
• Demo Mode
• Mic Level
• Solar Angle
• Save Users Memory (’07-08 models)
This screen allows the factory to collect log data to
troubleshoot navigation system issues.
• There is no card in the PC card Slot, the screen
appears as:
• However, if the factory provides a PC card, insert it
into the card slot (label side up). Follow the factory
logging VP data procedure for gathering test data and
properly ending the test.
08/08/21 14:07:33 61SNR030_230_0150
*43
*44
*45
GPS Send Time
Demo Mode
Mic Level
23-148
Navigation System
Send GPS Time
Return
GPS Time
Second
Year
Day
Hour
Minute
xxxx.xx.xx xx:xx:xx
Set
xxxx
xx
Month
xx
xx
xx
xx
Demo Mode
OFF
Demo
Speed Rate
150 ms
ON
OFF
Return
Return
Steering Switch
Mic Level
Mic Level
BACK
This screen is for factory use only. It allows adjustment
of the GPS time. This display updates in real time.
• GPS Time is the time as received from the GPS
satellites. It is in Greenwich Mean Time (GMT).
• Date, Hour, Minute, and Set should not be used.
This screen allows the navigation system to drive a
route, when the vehicle is stationary. Typical
applications include auto shows, and other events.
This feature allows a visitor to enter a destination, and
see the system drive to the destination. No speed signal
is needed.
• To initiate the mode, select ON.
• Changing the speed rate in ms (milliseconds) is
optional, and represents the time between updates of
the VP (vehicle position) movement.
– When you increase the rate, the VP slows down
because it is updated (moved) at a slower rate.
– When you decrease the rate, VP is faster because it
is updated (moved) more frequently.
– 1500 ms is VP at its slowest in demo mode.
– 150 ms is VP at its fastest in demo mode (Default).
• At key off, the setting automatically returns to the
default of Off.
This diagnostic screen allows you to independently test
the microphone and the navigation TALK and BACK
buttons. They are used to activate the voice control
system. The microphone is located near the map light
in the ceiling. It is directional, and works best if the
voice is coming from the drivers seat.
• Press the navigation TALK button on the steering
wheel, wait unit you hear a beep, and in a normal
voice say ‘‘testing’’. The TALK indicator on the screen
should momentarily turn green, and the text ‘‘Now
Recording...’’ should appear in yellow. If the talk
indicator on the screen does not briefly turn green,
then check the wiring from the navigation TALK
button to the navigation unit.
• If there is no Mic Level movement when you speak,
then you should check the wire running from the
microphone to the navigation unit.
• If the mic level bar is full or almost full without you
speaking or other back ground noise, replace the
microphone and recheck.
• Press the navigation BACK button on the steering
wheel. The Cancel indicator on the screen should
momentarily turn green. If it does not briefly turn
green, then check the wiring from the steering wheel
navigation BACK button to the navigation unit.
NOTE: The mic level should reach the 6th bar.
08/08/21 14:08:37 61SNR030_230_0151
*46
*47
Solar angle
Version
23-149
Solar Angle
Manual Tuning
Angle
Direction
Reliability
33.0
Vehicle
143.0
307.0
3
OFF
ON
DownLoad
Return
Version
Return
Program Flash
0.99.20.
Program Disc
0.99.0800
IPL
0.230.000
APL
0.200.122
DBOOT
0.241.122
System uCom
0.910.000
Model
SNRA
OFF
This screen graphically displays the sun’s position as
determined by GPS.
This screen is for factory use only, and allows
simulation of this feature for development purposes.
• The manual tuning button should always be OFF
• The Angle is the angle that the sun (shown with the
red dot) is above the horizon.
• The vehicle value represents the angle, clockwise
from North, to the direction that the vehicle position
(VP) icon is pointing (always points straight up).
• The direction value is the angle, measured clockwise
from the VP (straight up) to the suns position.
• The reliability ranges from 1 to 3, and represents the
accuracy of the Vehicle Position relative to the sun.
This screen displays the current version of the program,
and allows the loading of a new version of the program
either from a CD/DVD or from a PC card.
The Program Flash version should always be greater
than or equal to the Program Disc version. IPL, APL,
DBOOT, and system ucomare for factory use only.
The Model code is SNR and is for factory use only. This
code is stored on a chip in the navigation unit.
Therefore, every model has a unique part number for
the navigation unit.
NOTE: If any model number other than SNR is
displayed, replace the navigation unit with the correct
part. The model code tells the navigation unit what
software to load off the DVD.
Do not use Download, unless instructed to do so by the
factory.
08/08/21 14:08:37 61SNR030_230_0152
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст