Acura CSX. Manual — part 367
#
@
01
SNR9A0JB54175159634MAAT00
Special Tools Required
18-53
18-53
Tire Pressure Sensor Location
A
8. Turn the ignition switch to LOCK (0).
9. Disconnect the HDS from the DLC.
10. Test-drive the vehicle at 45 km/h (28 mph) or more
for at least 1 minute.
11. Make sure the low tire pressure indicator does not
blink.
12. Make sure the tires are inflated to the specified tire
pressure listed on the doorjamb sticker.
13. Turn the ignition switch to LOCK (0).
Bartech Wheelrite Tech300 TPMS tool J-48714
Available through Honda Canada Inc. Technical Tools
Department; Fax
866-398-8665/
e-mail: ch_technicaltools
ch.honda.com
NOTE:
• This procedure locates where the tire pressure
sensors 1, 2, 3, 4 are mounted, when activated by the
TPMS sensor initializer tool.
• Position the vehicle at least 3 m (10 ft) away from
other vehicles that have tire pressure sensors.
1. With the ignition switch in LOCK (0), connect the
HDS to the data link connector (DLC) (A) located
under the driver’s side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle
and the TPMS control unit. If it doesn’t,
troubleshoot the DLC circuit (see page 11-204).
4. Select Function Test from the mode menu, then
select Sensor Position Check on the HDS.
08/08/21 14:58:23 61SNR030_180_0053
#
@
01
SNR9A0JB54175159634MAAT00
Special Tools Required
18-53
18-53
Tire Pressure Sensor Location
A
8. Turn the ignition switch to LOCK (0).
9. Disconnect the HDS from the DLC.
10. Test-drive the vehicle at 45 km/h (28 mph) or more
for at least 1 minute.
11. Make sure the low tire pressure indicator does not
blink.
12. Make sure the tires are inflated to the specified tire
pressure listed on the doorjamb sticker.
13. Turn the ignition switch to LOCK (0).
Bartech Wheelrite Tech300 TPMS tool J-48714
Available through Honda Canada Inc. Technical Tools
Department; Fax
866-398-8665/
e-mail: ch_technicaltools
ch.honda.com
NOTE:
• This procedure locates where the tire pressure
sensors 1, 2, 3, 4 are mounted, when activated by the
TPMS sensor initializer tool.
• Position the vehicle at least 3 m (10 ft) away from
other vehicles that have tire pressure sensors.
1. With the ignition switch in LOCK (0), connect the
HDS to the data link connector (DLC) (A) located
under the driver’s side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle
and the TPMS control unit. If it doesn’t,
troubleshoot the DLC circuit (see page 11-204).
4. Select Function Test from the mode menu, then
select Sensor Position Check on the HDS.
08/08/21 14:58:23 61SNR030_180_0053
04
*01
18-54
TPMS
TPMS tool J-48714
TPMS tool J-48714
5. Turn on the TPMS tool by pressing the green select
button. Press the green select button until the
proper light sequence is illuminated as per the tool
user’s manual.
6. Follow the prompts on the HDS to activate the tire
pressure sensors using the TPMS tool.
NOTE: See the HDS Help menu for specific
instructions.
7. Check the HDS screen, and note the active sensor
reception order of tire pressure sensor 1, 2, 3, 4.
NOTE:
• If the sensor does not respond to the TPMS tool,
make sure the tool was turned on properly. Refer
to the HDS.
• If the tool start mode is OK, then rotate the tire
1/4 turn and retry.
• If the sensor still does not respond after one full
rotation of the tire, then check for DTC 32, 34, 36,
and 38 with the HDS.
8. Turn the ignition switch to LOCK (0).
08/08/21 14:58:24 61SNR030_180_0054
SNR9A0JB54175100000GAAT00
DTC
Detection Item
Troubleshooting
18-55
DTC Troubleshooting Index
11
Tire 1 Low Air Pressure
(see page 18-63)
13
Tire 2 Low Air Pressure
(see page 18-63)
15
Tire 3 Low Air Pressure
(see page 18-63)
17
Tire 4 Low Air Pressure
(see page 18-63)
21
Tire 1 Pressure Sensor Abnormally High Temperature
(see page 18-64)
22
Tire 2 Pressure Sensor Abnormally High Temperature
(see page 18-64)
23
Tire 3 Pressure Sensor Abnormally High Temperature
(see page 18-64)
24
Tire 4 Pressure Sensor Abnormally High Temperature
(see page 18-64)
31
Tire 1 Pressure Sensor Low Battery Voltage
(see page 18-65)
32
Tire 1 Pressure Sensor Transmission Failure
(see page 18-66)
33
Tire 2 Pressure Sensor Low Battery Voltage
(see page 18-65)
34
Tire 2 Pressure Sensor Transmission Failure
(see page 18-66)
35
Tire 3 Pressure Sensor Low Battery Voltage
(see page 18-65)
36
Tire 3 Pressure Sensor Transmission Failure
(see page 18-66)
37
Tire 4 Pressure Sensor Low Battery Voltage
(see page 18-65)
38
Tire 4 Pressure Sensor Transmission Failure
(see page 18-66)
41
Abnormal Signal Reception Error
(see page 18-67)
51
Tire 1 Pressure Sensor Registration Error
(see page 18-67)
53
Tire 2 Pressure Sensor Registration Error
(see page 18-67)
55
Tire 3 Pressure Sensor Registration Error
(see page 18-67)
57
Tire 4 Pressure Sensor Registration Error
(see page 18-67)
81
TPMS Control Unit Failure
(see page 18-68)
83
No VSP Signal
(see page 18-69)
85
F-CAN Communication Failure
(see page 18-69)
91
Tire 1 Pressure Sensor Internal Error
(see page 18-70)
93
Tire 2 Pressure Sensor Internal Error
(see page 18-70)
95
Tire 3 Pressure Sensor Internal Error
(see page 18-70)
97
Tire 4 Pressure Sensor Internal Error
(see page 18-70)
08/08/21 14:58:24 61SNR030_180_0055
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст