Acura CSX. Manual — part 22
06
*03
*04
*05
Installation
4-36
Charging System
A
B
C
6 x 1.0 mm
8 N·m (0.8 kgf·m,
6 lbf·ft)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
A
B
6 x 1.0 mm
10 N·m (1.0 kgf·m, 7.2 lbf·ft)
C
6 x 1.0 mm
10 N·m (1.0 kgf·m, 7.2 lbf·ft)
A
D
A
C
6 x 1.0 mm
10 N·m (1.0 kgf·m, 7.2 lbf·ft)
B
6 x 1.0 mm
10 N·m (1.0 kgf·m, 7.2 lbf·ft)
1. Install the alternator, then connect the alternator
connector (A) and the positive alternator cable (B)
and install the harness clamp (C). Make sure the
crimped side of the ring terminal faces away from
the alternator when you connect it.
2. Tighten the three bolts securing the alternator.
3. Install the bulkhead (A), then install the bulkhead
mounting bolts (B) and the A/C condenser bracket
mounting bolts (C).
4. Apply body paint to the bulkhead mounting bolts.
5. Install the radiator upper brackets (A), the radiator
cap base mounting bolts (B), and the bolts (C), and
connect the reservoir hose (D).
10
4-37
A
B
C
A
C
C
C
6. Connect the fan motor connectors (A) and the hood
switch connector (B), then install the harness
clamps (C).
7. Install the front grille cover (see page 20-163).
8. Install the drive belt (see page 4-31).
9. Do the battery terminal reconnecting procedure
(see page 22-68).
*01
SNR9A00A14100012901LAAT00
Exploded View
4-38
Charging System
Alternator Overhaul
ROTOR
FRONT BEARING
RETAINER
FRONT BEARING
DRIVE-END
HOUSING
PULLEY
PULLEY
LOCKNUT
TERMINAL
INSULATOR
BRUSH HOLDER
ASSEMBLY
REAR HOUSING
ASSEMBLY
END COVER
WASHER
02
03
04
05
Special Tools Required
4-39
B
A
• Driver 07749-0010000
• Attachment, 42 x 47 mm 07746-0010300
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Test the alternator and regulator before you
remove them (see page 4-28).
2. Remove the alternator (see page 4-34).
3. If the front bearing needs replacing, remove the
pulley locknut with a 10 mm wrench (A) and a
22 mm wrench (B). If necessary, use an impact
wrench.
4. Remove the harness stay and the three flange nuts
from the alternator.
5. Remove the end cover.
6. Remove the brush holder assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст