Acura CSX. Manual — part 503
+
+
―――
―――
+
―――
―――
―――
02
Fuse
Number
Amps
Component(s) or Circuit(s) Protected
22-63
2 3 4 5
1
1617
19
18
20
11
12
14
13
15
2627
29
28
30
2122
24
23
25
36 37
38
3132
34
33
35
10
6 7 8 9
21
20 A
MICU (
B H/L LO)
30 A
MICU (
B H/L LO)
22
Not used
23
Not used
24
20 A
Moonroof control unit/motor
25
20 A
MICU (
B DR LOCK)
26
20 A
Driver’s power window motor (via power window master switch)
27
Not used
28
15 A
Console accessory power socket (via console accessory power socket relay)
29
15 A
Front accessory power socket (via front accessory power socket relay)
30
20 A
Front passenger’s power window motor
31
Not used
32
20 A
Moonroof control unit/motor, Moonroof switch , Right rear power window motor
33
20 A
Left rear power window motor
34
Not used
35
7.5 A
Audio unit , Console accessory power socket relay, Front accessory power socket relay, HandsFreeLink control
unit , Ignition key switch, Navigation unit , Stereo amplifier
36
10 A
Climate control unit, Driver’s seat heater switch, Fan control relay and radiator fan relay (via A/C diode),
Passenger’s seat heater switch, Power mirrors (via power mirror switch), Under-hood fuse/relay box (A/C
compressor clutch relay, Blower motor relay, Power mirror defogger relay, Rear window defogger relay)
37
7.5 A
MICU (daytime running lights power supply)
38
30 A
MICU (IG 1 WIPER)
1: ’06-07 models
2: TYPE S model
3: Without HID
4: With HID
5: ’09 model with navigation system
6: Without navigation system
7: With navigation system
3
4
1
6
5
7
2
08/08/21 14:24:03 61SNR030_220_0065
−
SNR9A00J54230100000CCAT00
Ground
Component or Circuit Grounded
22-64
Ground Distribution
Ground to Components Index
G1
Battery
G2
Engine
G3
Transmission housing
G101
A/T clutch pressure control solenoid valves A, B, C (A/T), CKP sensor, CMP sensor A, CMP sensor B, Data link connector (DLC),
ECM/PCM (LG1), ECM/PCM (LG2), ECM/PCM (PG1), ECM/PCM (PG2), ECM/PCM (PGMETCS), EGR valve (K20Z2 engine), Ignition
coils, Immobilizer-keyless control unit, Rocker arm oil control solenoid, Rocker arm oil pressure switch, Transmission range
switch (A/T), VTC oil control solenoid valve
Shielding between the ECM/PCM and Knock sensor (KS) has wire.
Shielding between the ECM/PCM and Secondary HO2S (Sensor 2) has wire.
G201
Right fog light , Right front parking light, Right front side marker light, Right front turn signal light, Right headlight (high/low
beams), Right HID unit , Windshield washer motor, Windshield wiper motor
G202
ABS modulator-control unit , VSA modulator-control unit
G301
A/C condenser fan motor, Blower motor relay, ELD, Left fog light , Left front parking light, Left front side marker light, Left front
turn signal light, Left headlight (high/low beams), Left HID unit , Radiator fan motor (via fan control relay)
G401
Brake fluid level switch, Clutch interlock switch (M/T), Clutch pedal position switch (M/T), Hood switch, MICU (PG), Power
transistor, Washer fluid level switch (G401 connects to G601 via under-dash fuse/relay box)
G402
EPS control unit
G403
Torque sensor
G501
Dash lights brightness controller and odometer select/reset switch, Driver’s door key cylinder switch, Driver’s door lock knob
switch, HandsFreeLink control unit , MICU (SG), VSA OFF switch
G502
Data link connector (DLC), Front accessory power socket, Glove box light, Right power mirror defogger, Right side turn signal
light
G503
Accessory power socket relays (front and console), Driver’s door lock switch, Gauge control module (tach), Left power mirror
defogger, Left side turn signal light, Moonroof control unit/motor, Power mirror switch light, Power mirror switch, Power
window master switch (main switch), Power window master switch, Vanity mirror lights (driver’s and front passenger’s)
G504
Cable reel (steering wheel switches ground), Climate control unit, Front passenger’s door lock knob switch, Front passenger’s
door lock switch, Gauge control module (speedo), Gauge control module (tach), Ignition key switch, Navigation unit , TPMS
control unit
G505
Audio unit , Navigation unit
G506
Memory erase signal (MES) connector, SRS unit (2 wires)
G601
A/T gear position console panel light/Park-pin switch (A/T), Console accessory power socket , Fuel pump, MICU (PG), Seat
heater relays (driver’s and front passenger’s), Seat heater switches (driver’s and front passenger’s), Seat heaters (driver’s and
front passenger’s), Stereo amplifier
(G601 connects to G401 via under-dash fuse/relay box)
Shielding between the left side impact sensor (FIRST) and rear safing sensor has wire.
Shielding between the SRS unit and left side impact sensor (FIRST) has wire.
G602
Driver’s seat belt buckle switch, Front passenger’s seat belt buckle switch, Left rear door lock knob switch, MICU (SG), MICU
service check connector, ODS unit, Right rear door lock knob switch, Yaw rate-lateral acceleration sensor
Shielding between the right side impact sensor (FIRST) and right side impact sensor (SECOND) have wires.
Shielding between the SRS unit and right side impact sensor (FIRST) has wire.
G603
Noise condenser
Shielding between the rear safing sensor and left side impact sensor (SECOND) has wire.
G701
High mount brake light, Left back-up light, Left inner taillight, Left rear side marker light, Left rear turn signal light, Left taillight/
brake light, License plate lights, Right back-up light, Right inner taillight, Right rear side marker light, Right rear turn signal light,
Right taillight/brake light, Trunk lid release actuator/Trunk lid latch switch
G801
Rear window defogger (
)
1:
’06-07 Touring and Premium models
2:
’07 TYPE S and ’08-09 models
3:
’08-09 models
4:
TYPE S and ’08 premium and ’09 models
5:
With HID
6:
Without navigation system
7:
With navigation system
8:
’09 model with navigation system
9:
’06-08 models, and ’09 model without navigation system
10: TYPE S model
4
5
1
2
4
5
8
2
3
7
3
6
7
9
10
2
08/08/21 14:24:03 61SNR030_220_0066
*01
SNR9A00J54226562100KDAT10
Special Tools Required
Removal
Installation
22-65
Under-hood Fuse/Relay Box
Removal and Installation
A
B
Relay puller 07AAC-000A1A0
1. Do the battery terminal disconnection procedure
(see page 22-68).
2. Remove the screws (A) for the alternator and
battery cable terminals from the under-hood fuse/
relay box.
3. Remove the bottom cover (B) from the under-hood
fuse/relay box.
4. Disconnect the connectors from the under-hood
fuse/relay box.
5. Carefully remove the relays using the relay puller.
NOTE: Do not use pliers. Pliers will damage the
relays, which could cause the engine to stall or not
start.
1. Install the relays and connect the connectors to the
under-hood fuse/relay box, then install the under-
hood fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of
removal.
3. Do the battery terminal reconnection procedure
(see page 22-68).
4. Confirm that all systems work properly.
08/08/21 14:24:03 61SNR030_220_0067
01
SNR9A00J54226562001KDAT00
Special Tools Required
Removal
Installation
22-66
Under-dash Fuse/Relay Box
Removal and Installation
A
Relay puller 07AAC-000A1A0
SRS components are located in this area. Review the
SRS component locations (see page 24-11), and
precautions and procedures (see page 24-13) before
doing repairs or serving.
1. Do the battery terminal disconnection procedure
(see page 22-68).
2. Remove the driver’s dashboard lower cover
(see page 20-102).
3. Disconnect the connectors from the fuse side of the
under-dash fuse/relay box (A).
4. Remove the mounting bolt, and pull the fuse/relay
box away from the body.
5. Disconnect the connectors from the back side of the
under-dash fuse/relay box, then remove the under-
dash fuse/relay box.
6. Carefully remove the relays using the relay puller.
NOTE: Do not use pliers. Pliers will damage the
relays, which could cause the engine to stall or not
start.
1. Install the relays and connect the connectors to the
under-dash fuse/relay box, then install the under-
dash fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of
removal.
3. Do the battery terminal reconnection procedure
(see page 22-68).
4. Register the immobilizer system with the HDS
(see page 22-329).
NOTE: The imoes unit is built into the MICU which
is part of the under-dash fuse/relay box. Because of
this construction, the imoes must be registered, or
the vehicle will not start.
5. Confirm that all systems work properly.
08/08/21 14:24:04 61SNR030_220_0068
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст