Acura CSX. Manual — part 591
03
04
Without navigation 1 CD type
23-81
A
A
B
B
C
5. Remove the screws and the brackets (A).
6. Install the audio unit in the reverse order of
removal, and make sure all connectors and
antenna lead are secure.
SRS components are located in this area. Review the
SRS component location (see page 24-11).
Also review the precautions and procedures (see page
24-13) in the SRS section before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard and related
parts.
• Lay a workshop towel under the parts when working
on them to protect the face panel from scratches or
other damage.
• Do not work in a dusty or dirty place.
• Discharge static electricity from your body before and
during the work.
• Do not touch the circuit board(s) with your bare
hands.
• Do not work with dirty hands.
• Be careful not to fold the flat plate cable.
• Do not touch the terminal connector of the flat plate
cable with your bare hands. (If you have touched it,
wipe it off thoroughly.)
• Eject all the discs before removing the audio unit to
prevent damaging the CD player’s load mechanism.
• If you are replacing the audio unit, write down the
sudio presets (if possible), and enter them into the
new audio unit.
1. Remove the meter inner visor (see page 20-100).
2. Remove the center pocket hole lid and bolts, then
pull out the center panel (A).
3. Disconnect the connectors (B) and the air hose (C),
then remove the center panel.
08/08/21 14:05:36 61SNR030_230_0084
05
06
*01
SNR9ANEJ10311167301KDAT01
’08 model with navigation
23-82
23-82
Audio System
XM Receiver Removal/Installation
A
A
A
B
A
C
A
A
B
4. Remove the bolts, screws and the brackets (A).
5. Remove the screws, rear covers (A) and the audio
unit (B) from the center panel display (C).
6. Install the audio unit in the reverse order of
removal, and make sure all connectors and
antenna lead are secure.
1. Open the trunk lid and remove the right trunk side
trim panel (see page 20-82).
2. Disconnect the connectors (A) from the XM
receiver (B).
3. Loosen the three bolts, and remove the XM
receiver.
4. Install the XM receiver in the reverse order of
removal.
08/08/21 14:05:36 61SNR030_230_0085
05
06
*01
SNR9ANEJ10311167301KDAT01
’08 model with navigation
23-82
23-82
Audio System
XM Receiver Removal/Installation
A
A
A
B
A
C
A
A
B
4. Remove the bolts, screws and the brackets (A).
5. Remove the screws, rear covers (A) and the audio
unit (B) from the center panel display (C).
6. Install the audio unit in the reverse order of
removal, and make sure all connectors and
antenna lead are secure.
1. Open the trunk lid and remove the right trunk side
trim panel (see page 20-82).
2. Disconnect the connectors (A) from the XM
receiver (B).
3. Loosen the three bolts, and remove the XM
receiver.
4. Install the XM receiver in the reverse order of
removal.
08/08/21 14:05:36 61SNR030_230_0085
01
SNR9AGNJ10311157191KDAT02
01
SNR9A0KJ10370327201KBAT80
Type S model
Front Door Speaker
23-83
23-83
Stereo Amplifier Removal/
Installation
Speaker Replacement
A
C
B
A
B
C
B
1. Slide the driver’s front seat forward fully.
2. Remove the amp cover (A), then disconnect the
connectors (B).
3. Remove the mounting bolts, then remove the
stereo amplifier (C).
4. Install the stereo amplifier in the reverse order of
removal.
1. Remove the front door panel (see page 20-7).
2. Remove the screw. Then lift the speaker (A) straight
up to release the lower clips (B).
3. Disconnect the 2P connector (C), and remove the
speaker.
4. Install the speaker in the reverse order of removal.
08/08/21 14:05:37 61SNR030_230_0086
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст