Acura CSX. Manual — part 603
SNR9ANDJ36100000000FAAT28
−
*11
SNR9ANDJ36100000000FAAT04
−
−
DVD read error messages
System always comes up in in-line
diagnostic mode
YES
NO
23-127
23-127
Start Diag
Exit Diag
Navi.ECU
In Line Diag
GPS Antenna
Display
Radio
Delete
Done
0
1
2
3
6
5
4
7
8
9
BACK
XXXX Correct PIN
KA
NOTE:
• Check the vehicle battery condition first.
• Make sure that the correct DVD color and version are
installed.
• Check any official Honda service website for more
service information about the navigation system.
• Check the Navigation System Manual for a list of
common DVD screen error messages and the
probable cause.
• Go into the Diagnostic Menu, and use the Car Status
test (see page 23-141) to check the status of the
display.
1. Check the DVD-ROM reading surface for scratches.
Replace the DVD-ROM.
If the problem occurs occasionally when the
system is cold, this is normal. If the problem occurs
frequently when driving, replace the navigation
unit (see page 23-155).
1. When a navigation unit is powered up for the first
time at the factory, the factory diagnosis screen (In
Line Diag) appears. Normally the factory performs
the steps necessary to verify proper operation and
terminate the factory diagnostic. Until the proper
confirmation sequence is performed, the screen
will appear every time the vehicle is started.
2. Follow the steps to prevent the screen from
showing up in the future:
• Hold down the buttons (Menu, Map/Guide, and
Cancel) for about 5 seconds (the Select Diagnosis
Items screen appears).
• Hold down the Map/Guide button for 5
10 seconds (A screen with a Complete button
appears).
• Touch Complete, and then the Return button (the
system may re-boot).
• Restart the vehicle, and confirm normal
operation by completing the PDI of the
navigation system Service Bulletin.
Ar e ther e scr atches?
08/08/21 14:07:27 61SNR030_230_0130
+
SNR9ANDJ36100000000FAAT11
SNR9ANDJ36100000000FAAT12
−
−
−
−
−
−
Display day/night mode does not work or
does not work properly
System locks up or freezes constantly
YES
NO
YES
NO
YES
NO
23-128
23-128
Navigation System
NOTE:
• Check the vehicle battery condition first.
• Check the connectors for poor connection or loose
terminals.
• Before troubleshooting, get the navigation system
anti-theft code.
• After troubleshooting, enter the navigation system
anti-theft code.
• Full brightness on the instrument panel brightness
control with the head lights turned on causes the
system to stay in the day mode, even when the lights
are on.
1. Make sure the instrument panel brightness control
is not on full brightness. Turn the headlights on and
adjust the dash brightness to the middle range.
2. Change the day/night mode under Set-up to AUTO,
and recheck.
The system is OK at this time.
Go to step 3.
3. Go into the Diagnostic Menu and use the Car Status
test to check for an ILL signal (see page 23-141).
Replace the navigation unit (see page 23-155).
Check the ILL
circuit between the
navigation unit and the No. 14 (7.5 A) fuse in the
under-dash fuse/relay box.
NOTE:
• Check the vehicle battery condition first.
• Make sure that the correct DVD color and version are
installed.
• Check any official Honda service website for more
service information about the navigation system.
1. Start the engine and turn the ignition switch to
LOCK (0), then turn the ignition switch to ON (II).
The system is OK at this time.
Check the DVD for scratches or damage, and
the navigation unit for water damage. If OK, go into
the Diagnostic Menu and do all of the Unit Check
tests (see page 23-139). Also check for low battery
charge or poor charging system performance.
Does the display change to day and night modes
when tur ning the headlights on and of f ?
Is the ILL signal OK ?
Does the system r eboot?
08/08/21 14:07:28 61SNR030_230_0131
SNR9ANDJ36100000000FAAT27
SNR9ANDJ36100000000FAAT17
−
−
−
−
−
−
−
−
−
−
Navigation display stays on with ignition
switch in LOCK (0)
Navigation cannot control audio system
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
23-129
23-129
NOTE:
• Check the connectors for poor connections or loose
terminals.
• Before troubleshooting, get the navigation system
anti-theft code, then write down the audio presets.
• After troubleshooting, re-enter the anti-theft code,
and re-initialize the navigation system, then enter the
audio presets.
• Check for aftermarket accessories that use the same
power circuit. A feedback can cause this problem.
1. Remove the key from the ignition.
Go to step 2.
The system is OK at this time.
2. The vehicle may have been used as a
demonstration vehicle at an event like an auto
show. In these events, power is often jumpered to
the navigation system so that the ignition key is not
needed in the vehicle. At the end of the show, the
jumper wire may not have been removed. Check
the navigation unit connector A (17P) for a non-
factory jumper wire in series with the factory cable.
Remove the jumper wire, and re-test. Return
the jumper wire to Tech Line.
Go to step 3.
3. Check if the audio unit works.
Troubleshoot the ACC circuit for a short to
power with another circuit.
Replace the navigation unit (see page 23-155).
NOTE:
• Check the vehicle battery condition first.
• Verify that the correct navigation unit is installed for
this model. Go into the Diagnostic mode and use
Version (see page 23-149).
• Check for connectors for poor connections or loose
terminals.
• Before troubleshooting, make sure you have anti-
theft codes for the navigation system.
• After troubleshooting, enter the anti-theft codes for
the navigation system.
• Make sure that the correct navigation DVD color and
version are installed.
• Inspect the navigation DVD for dirt or damage.
• Check any official Honda service website for more
service information about the navigation system.
1. Make sure the anti-theft code for the navigation
system is entered.
2. Go into the Diagnostic Menu and use the Navi
System Link test (see page 23-136).
Do the troubleshooting for the voice
guidance cannot be heard (see page 23-122).
Go to step 3.
3. Substitute a known-good navigation unit (see page
23-155), and recheck.
Replace the navigation unit (see page 23-155).
Do the audio system troubleshooting.
Does the navigation scr een stay on?
Is ther e a jumper wir e?
Does the audio unit wor k with the ignition switch
of f ?
Is the Radio icon r ed?
Can the navigation contr ol audio?
08/08/21 14:07:28 61SNR030_230_0132
SNR9ANDJ36100000000FAAT15
SNR9ANEJ36100000000FAAT16
−
−
−
−
Navigation cannot control HVAC by voice
command
Navigation cannot control XM radio
YES
NO
YES
NO
23-130
23-130
Navigation System
NOTE:
• Make sure that the correct DVD color and version are
installed.
• Check any official Honda service website for more
service information about the navigation system.
• Check the connectors for poor connections or loose
terminals.
• Before troubleshooting, get the navigation system
anti-theft code.
• After troubleshooting, enter the navigation system
anti-theft code.
• Verify that the correct navigation unit is installed for
this model. Go into the Diagnostic Menu and use
Version (see page 23-149).
1. Go into the Diagnostic Menu and use the Navi
System Link test (see page 23-136).
Do the climate control system
troubleshooting.
Replace the navigation unit (see page 23-155).
NOTE:
• Check the vehicle battery condition first.
• Make sure that the correct DVD color and version are
installed.
• Check any official Honda service website for more
service information about the navigation system.
1. Substitute a known-good navigation unit (see page
23-155), and recheck.
Replace the navigation unit (see page 23-155).
Do the audio system troubleshooting.
Is the Air -con icon r ed?
Can the navigation contr ol the X M r adio?
08/08/21 14:07:28 61SNR030_230_0133
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст