Acura RSX Honda Integra. Manual — part 53
01
01
01
S6M6A000000000J0701PAAT00
Ref. No.
Tool Number
Description
Qty
7-2
Engine Block
Special Tools
07ZAD-PNAA100
Oil Seal Driver Attachment, 96 mm
1
07746-0010700
Attachment, 24 x 26 mm
1
07749-0010000
Driver
1
*01
S6M6A00A18300000000DAAT00
7-3
Component Location Index
THRUST WASHERS
FLYWHEEL (M/T)
CRANKSHAFT OIL SEAL
CRANKSHAFT
MAIN BEARINGS
DOWEL PINS
BAFFLE PLATE
LOWER BLOCK
DRIVE PLATE (A/T)
(cont’d)
Installation, step 21 on page 7-28
Installation - in car, page 7-32
End play, page 7-5
Runout, page 7-15
Out-of-round, page 7-15
Removal, page 7-13
Installation, page 7-26
Oil clearance, page 7-6
Selection, page 7-7
*02
7-4
Engine Block
Component Location Index (cont’d)
PISTON RINGS
PISTON PIN
CONNECTING ROD
CONNECTING ROD
BEARINGS
CONNECTING ROD
BEARING CAP
PISTON
ENGINE BLOCK
CONNECTING ROD BOLTS
Replacement, page 7-22
Removal, page 7-19
Inspection, page 7-20
Installation, page 7-21
End play, page 7-5
Small end measurement, page 7-20
Oil clearance, page 7-8
Selection, page 7-9
Removal, page 7-13
Measurement, page 7-16
Cylinder bore inspection, page 7-16
Warpage inspection, page 7-16
Cylinder bore honing, page 7-18
Ridge removal, step 14 on page 7-14
Inspection, page 7-25
01
02
S6M6A00A18316200000MAAT00
−
−
−
−
Connecting Rod End Play
Standard (New): 0.15
0.30 mm (0.006
0.012 in.)
Service Limit:
0.40 mm (0.016 in.)
Crankshaft End Play
Standard (New): 0.10
0.35 mm (0.004
0.014 in.)
Service Limit:
0.45 mm (0.018 in.)
7-5
Connecting Rod and Crankshaft End Play Inspection
1. Remove the oil pump (see page 8-13).
2. Remove the baffle plate (see step 7 on page 7-13).
3. Measure the connecting rod end play with a feeler
gauge between the connecting rod and crankshaft.
4. If the connecting rod end play is out-of-tolerance,
install a new connecting rod, and recheck. If it is
still out-of-tolerance; replace the crankshaft (see
step 8 on page 7-13).
5. Push the crankshaft firmly away from the dial
indicator, and zero the dial against the end of the
crankshaft. Then pull the crankshaft firmly back
toward the indicator; the dial reading should not
exceed the service limit.
6. If the end play is out-of-tolerance, replace the thrust
washers and recheck. If it is still out-of-tolerance,
replace the crankshaft (see step 8 on page 7-13).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст