Chevrolet Silverado / GMC Sierra. Manual — part 1916
1. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover
Replacement.
2. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer
to Differential Carrier Assembly Replacement (1500 FWD) or Differential Carrier
Assembly Replacement (2500 4WD) .
3. Remove the two lower engine mount to engine bolts (1).
4. Remove the starter motor. Refer to Starter Motor Replacement (4.8L, 5.3L, 6.0L, and
6.2L) .
2008 Chevrolet Silverado 1500
2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Fig. 45: Locating Tab On Engine Block
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: DO NOT raise and/or support the engine by the crankshaft
balancer or oil pan.
2008 Chevrolet Silverado 1500
2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
5. Place an adjustable (screw type) jack to the tab (1) located on the engine block.
Fig. 46: View Of Engine Mount To Frame Bolts
Courtesy of GENERAL MOTORS CORP.
6. Remove the engine mount to frame bolts (1).
2008 Chevrolet Silverado 1500
2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Fig. 47: View Of Engine Mount To Engine Bolts
Courtesy of GENERAL MOTORS CORP.
7. Remove the two top engine mount to engine bolts (1).
8. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove
the engine mount.
2008 Chevrolet Silverado 1500
2008 ENGINE Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст