Chevrolet Silverado / GMC Sierra. Manual — part 2666
1. Push mirror glass bottom outboard (1) corner, furthest away from the vehicle door, as
far as possible into the mirror housing.
2. Place fingers tips behind the top inboard edge (2) corner, closest to the vehicle door.
3. Pull the mirror glass with light pressure until the glass comes loose.
4. Holding the mirror face, disconnect the electrical connectors from the back of the
mirror.
Installation Procedure
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 11: Positioning Mirror Face On Mirror Housing
Courtesy of GENERAL MOTORS CORP.
1. Position the mirror face on a angle to the mirror housing.
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 12: Pushing Downward & Inward To Lock Glass In Place
Courtesy of GENERAL MOTORS CORP.
2. Install the mirror face as follows:
1. Holding the mirror face, connect the electrical connectors to the back of the mirror.
2. Position the mirror face to the motor retainer tabs.
3. Position the hand in the center of the mirror face.
4. Apply light pressure to the face.
5. Push downward and inward to lock in place.
6. Inspect the mirror face for proper operation.
INSIDE REARVIEW MIRROR REPLACEMENT
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 13: Identifying Inside Rearview Mirror Components
Courtesy of GENERAL MOTORS CORP.
REARVIEW MIRROR SUPPORT INSTALLATION
Tools Required
Safety Razor or Utility Knife
Installation
1. Determine the location of the mirror mounting base by marking the outside of the
windshield with a marking pencil where the base was previously located. If it is not clear
where the base was mounted, use the following steps to determine where the base should be
Callout
Component Name
1
Rearview Mirror Support Cover
2
Rearview Mirror Support Wire Cover
Procedure:
Disconnect the wiring harness from the rearview mirror.
3
Rearview Mirror
Procedure:
With both hands on the mirror, rock it from side to side while sliding upward,
this will assist in the releasing of the mirror from the mounting tab.
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст