Chevrolet Silverado / GMC Sierra. Manual — part 2594
TRANSMISSION DOES NOT SHIFT INTO ONE GEAR
Diagnostic Aids
When the manual transmission will not transmit power from the engine to the wheels and one gear
8
Inspect the engine and/or transmission mounts
for loose fasteners.
Did you find any loose fasteners?
Go to Step 9
Go to Step 10
9
Tighten the engine mount and/or transmission
mount fasteners to specifications. Refer to
Fastener Tightening Specifications.
Did you find and repair the condition?
System OK
Go to Step 10
10
Inspect the clutch housing for loose bolts or
misalignment.
Did you find any loose bolts or misalignment?
Go to Step 11
Go to Step 12
11
Tighten any loose housing bolts and/or align the
housing. Refer to Fastener Tightening
Specifications.
Did you find and repair the condition?
System OK
Go to Step 12
12
1. Remove the transmission. Refer to
Transmission Replacement.
2. Disassemble and inspect the following
internal components for wear or damage:
Gearshift
Transmission gears
Bearings
Did you find any worn or damaged
components?
Go to Step 13
System OK
13
1. Replace worn or damaged components, as
necessary.
2. Install the transmission. Refer to
Transmission Replacement.
Did you find and repair the condition?
Go to Step 14
Go to Diagnostic
Aids
14
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 1
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
will not shift, it is possible that the gear is stripped. You should also perform a static shift and
dynamic shift test. If the transmission will not shift in all gears, it is possible the input or
countershaft gears are stripped or there is a broken input or output shaft. Sometimes the
transmission shift control may not be operating properly.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
2: This step inspects for worn or damaged shift control components.
4: This step inspects for any conditions with the hydraulic system.
8: This step inspects for worn or damaged internal components.
Step
Action
Yes
No
DEFINITION: The transmission does not shift into a gear.
1
Did you review the Symptoms - Manual
Transmission and perform the necessary
inspections?
Go to Step 2
Go to Symptoms
- Manual
Transmission
2
Inspect the transmission shift lever operation.
Is the control worn, binding, or damaged?
Go to Step 3
Go to Step 3
3
Replace the transmission shift lever. Refer to
Transmission Control Lever Knob
Replacement and Transmission Control
Lever Boot Replacement .
Did you find and repair the condition?
System OK
Go to Step 4
4
Inspect the hydraulic clutch operation. Refer to
Symptoms - Clutch .
Is the clutch operating properly?
Go to Step 6
Go to Step 5
5
Replace the concentric slave cylinder.
Did you find and repair the condition?
System OK
Go to Step 6
6
1. Remove the transmission. Refer to
Transmission Replacement.
2. Inspect the transmission input shaft and the
clutch pilot bearing.
Is there signs of the input shaft binding in the
pilot bearing?
Go to Step 7
Go to Step 8
1. Inspect the clutch pilot bearing for
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
TRANSMISSION LOCKED IN ONE GEAR
Diagnostic Aids
If the transmission is locked, engaging the clutch will stop the engine. If the shift control
components and the clutch system operations are operating properly, the condition is caused by
internal damage, such as a dented or damaged shift fork. The transmission must be removed from
the vehicle for repairs. You should also perform a static shift test and dynamic shift test.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
6: This step inspects for a faulty actuator cylinder.
7
damage.
2. Replace the clutch pilot bearing. Refer to
Clutch Pilot Bearing Replacement .
Did you find and repair the condition?
System OK
Go to Step 8
8
Disassemble and inspect the following
transmission internal components for wear or
damage:
Gearshift components
Transmission gears
Bearings
Did you find any worn or damaged
components?
Go to Step 9
System OK
9
1. Replace worn or damaged components, as
necessary.
2. Install the transmission. Refer to
Transmission Replacement.
Did you find and repair the condition?
Go to Step 10
Go to Diagnostic
Aids
10
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 1
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
8: This step inspects for a dented or damaged shift fork.
Step
Action
Yes
No
DEFINITION: The transmission cannot be shifted out of a gear.
1
Did you review the Symptoms - Manual
Transmission and perform the necessary
inspections?
Go to Step 2
Go to Symptoms
- Manual
Transmission
2
Inspect the transmission fluid level. Refer to
Transmission Fluid Replacement.
Is the transmission fluid level correct?
Go to Step 4
Go to Step 3
3
Add transmission fluid, if necessary.
Can you shift the transmission out of gear?
System OK
Go to Step 5
4
Inspect for the correct type of transmission
fluid.
Is the correct type of transmission fluid being
used?
Go to Step 6
Go to Step 5
5
Drain the transmission fluid and fill the
transmission with the correct type of fluid.
Refer to Transmission Fluid Replacement.
Did you find and repair the condition?
System OK
Go to Step 6
6
Inspect the concentric slave cylinder operation.
Refer to Symptoms - Clutch .
Is the clutch actuator operating properly?
Go to Step 8
Go to Step 7
7
Replace the concentric slave cylinder.
Did you find and repair the condition?
System OK
Go to Step 8
8
1. Remove the transmission. Refer to
Transmission Replacement.
2. Disassemble and inspect the transmission
for a dented or damaged shift fork.
Did you find a dented or damaged shift fork?
Go to Step 9
Go to Step 10
9
1. Replace worn or damaged components, as
necessary.
2. Install the transmission. Refer to
Transmission Replacement.
Did you find and repair the condition?
System OK
Go to Step 10
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст