Chevrolet Silverado / GMC Sierra. Manual — part 1421
Replacement.
10. Install the brake caliper. Refer to Rear Brake Caliper Replacement (JH6, JH7) or Rear
Brake Caliper Replacement (JD9) .
11. Install the wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
12. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
13. Fill the rear axle. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid
and Lubricant Recommendations .
14. Lower the vehicle.
REAR AXLE SHAFT SEAL AND/OR BEARING REPLACEMENT (W/O VSES)
Speical Tools
J 2619-01 Slide Hammer
J 8092 Universal Driver Handle 3/4 in-10
J 21128 Axle Pinion Oil Seal Installer
J 23690 Axle Shaft Bearing Installer
J 44685 Rear Axle Seal and Bearing Remover. See Special Tools.
J 45857 Tone Wheel and/or Bearing Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation .
3. Remove the rear axle shaft. Refer to Rear Axle Shaft Replacement (8.6 Inch Axle
w/Drum Brake w/VSES) or Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum
Brakes w/o VSES) or Rear Axle Shaft Replacement (8.6, 9.5 Inch Axles w/VSES).
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 79: View Of Axle Shaft Seal & Bearing
Courtesy of GENERAL MOTORS CORP.
4. Using the J 44685 (1) and the J 2619-01 (2), remove the axle shaft seal. See Special Tools.
IMPORTANT: The following service procedure is for NON-VSES vehciles.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 80: Removing Axle Shaft Seal & Bearing Using J 45857 & J 2619-01
Courtesy of GENERAL MOTORS CORP.
5. Using the J 45857 (1) and the J 2619-01 (2), remove the axle seal, bearing, and the tone
wheel.
Installation Procedure
IMPORTANT: The following service procedure is for VSES equipped
vehicles.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 81: Installing Axle Shaft Bearing
Courtesy of GENERAL MOTORS CORP.
1. Using the J 23690 (1) and the J 8092 (2), install the axle shaft bearing.
2. Drive the axle shaft bearing into the housing until the tool bottoms against the tube.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст