DAF 95XF. Manual — part 622

6

©

200419

Preface

©

200419

7

Directions for use

DIRECTIONS FOR USE

The basic arrangement of the special tools manual is virtually the same as the arrangement of the
workshop manual.
Groups 1 to 9 contain the special tools for the respective main component.
Group 0 (General) contains universal special tools and special tools used in several groups.

Note:
If a special tool does not occur in the relevant section, look in group 0 (General).
The special tool in question is then one that occurs in several groups.

At the beginning of every group there is a table of contents containing the following columns

-

DAF code number

-

Relevant vehicle series

-

Relevant main components

-

Page number

If a tool is used for a main component or vehicle series, this is indicated by a code in the column (1-2-3-R).
This code has the following meaning:
1 - tool for carrying out maintenance work and repair work resulting from it.
2 - tool for frequently recurring work.
3 - tool for less frequently recurring work.
R - replacement part of a tool.

Explanations of the abbreviations used in the tables are:

i.c.w.

in combination with

A_1000/ 2000

Allison 1000/2000

TS12612

Twin Splitter 12612

E.PTO

Version with power take-off

HGS

Gearbox with Hydraulic Gear Shift

Voith-ret.

Version with Voith retarder

150_S/152_S/156_S/182_S/186_S

150N/152N/156N/182N/186N-shaft in disc brake version

150N/152N/156N/182N/186N

150N/152N/156N/182N/186N-shaft in dum brake version

09G075

Co-steering rear axle

09N075/09N220

Trailing rear axle in drum brake version

09N044

Leading rear axle (FTP vehicle type)

EMAS

Electro-hydraulic multi-axle steering

EVS

Electronic vehicle steering

RAS-EC

Rear axle steering - electronically controlled

ST_TRW

TRW steering boxes

ST_ZF

ZF steering boxes

8

©

200419

Directions for use

©

200419

9

TOOLS, GENERAL

0

0

USE OF TABLE OF CONTENTS

At the beginning of every group there is a table of contents containing the following columns:

-

DAF code number of the special tool

-

relevant vehicle series

-

relevant main components or systems

-

page number of the figure

If a tool is used for a main component, system or vehicle series, this is indicated by a code in the
column (1-2-3-R).
This code has the following meaning:
1 - tool for carrying out maintenance work and repair work resulting from it.
2 - tool for frequently recurring work.
3 - tool for less frequently recurring work.
R - replacement part of a tool.