DAF 95XF. Manual — part 516
3
PTO
Removal and installation
4-10
4.9 REMOVAL AND INSTALLATION, PTO AUXILIARY SHAFT FOR GEARBOX
VERSION WITH INTARDER
Removal, auxiliary shaft with intarder
1.
Drain as much gearbox oil as necessary
and collect it in a clean container.
2.
Remove the PTO.
3.
Remove the intermediate housing from the
rear cover of the gearbox.
4.
Remove the O-ring and the gasket.
5.
Remove the auxiliary shaft with bearing and
lock ring from the rear cover of the gearbox.
6.
Remove the lock ring and the auxiliary shaft
bearing.
Installation, auxiliary shaft with intarder
1.
Note:
The auxiliary shaft can be installed without
any measurements being taken.
Install the bearing and the lock ring on the
auxiliary shaft.
2.
Install the auxiliary shaft in the rear cover of
the gearbox.
3.
Install the intermediate housing with O-ring
and gasket onto the rear cover of the
gearbox.
4.
Install the PTO.
5.
Check the oil level in the gearbox.
11
ǹ 0002
Maintenance manual
95XF
DW03247106
E 200424 DAF Trucks N.V., Eindhoven,
the Netherlands
In the interest of continuing product
development, DAF reserves the right to change
specification or equipment at any time without
notice.
No part of this publication may be reproduced
and/or published by printing, photocopying,
microfilming or by any other means without the
manufacturer’s prior permission in writing.
200424
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст