DAF 95XF. Manual — part 198
©
200438
2-1
System inspection with DAVIE XD
ABS-D AND ABS/ASR-E
DAVIE XD diagnostics manual
10
2. SYSTEM INSPECTION WITH DAVIE XD
2.1 GENERAL
If DAVIE is being used to communicate with the
ABS/ASR electronic unit, the following points
need to be taken into account:
If ABS valve failures occur while driving, the fault
lamp will go out after switching the vehicle ignition
off and on if the fault is no longer active.
Should faults occur with the wheel speed sensors
while driving, switch the vehicle ignition off and
on; the fault lamp should then remain on if the
fault is no longer present.
The fault lamp will not go out until the vehicle has
reached a speed of at least 7 km/h.
If DAVIE XD has been used to erase faults from
the memory of the electronic unit, the fault lamp
will go out when the vehicle has reached a speed
of at least 7 km/h.
In some "direct test" functions, it is possible to
drive the vehicle while communications are taking
place between DAVIE XD and the ABS/ASR unit.
With the remaining "direct test" functions,
communications between DAVIE XD and the
electronic unit will be interrupted.
If a new ABS/ASR electronic unit is fitted, the unit
will "recognise" whether the vehicle has an ASR
system when the vehicle ignition is switched on.
If an electronic unit is subsequently fitted in a
vehicle that does not have an ASR system, the
unit will always output ASR error messages.
Whenever an ABS/ASR electronic unit is
replaced, it is therefore important to reset the unit
using DAVIE/XD.
ABS-D AND ABS/ASR-E
2-2
©
200438
System inspection with DAVIE XD
10
DAVIE XD diagnostics manual
©
200438
1
Contents
D3LC (ACH-EA)
DAVIE XD diagnostics manual
11
11 D3LC (ACH-EA)
CONTENTS
Page
Date
D3LC (ACH-EA)
2
©
200438
Contents
11
DAVIE XD diagnostics manual
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст