DAF CF65, CF75, CF85 Series . Manual — part 1169
©
200423
4-17
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
4.12 REMOVAL AND INSTALLATION, GEARBOX FILTER ELEMENT
To prevent skin injury, avoid
unnecessary contact with the
drained oil.
ZF gearbox with integrated retarder
Removing the gearbox filter element
1.
Remove the attachment bolt (1) of the oil
filter.
2.
Pull the filter cover with the filter from the
filter housing.
3.
Remove the filter (3) from the filter cover (2).
Do not clean the filter. The filter must always
be replaced.
Note:
If the magnetic disk is still attached to the
back of the filter, separate it from the filter
element and fit it on the new filter element.
}
M3052
1
M3053
M3054
2
3
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-18
©
200423
Removal and installation
5
ΧΦ75 series
Installing the gearbox filter element
1.
Check the O-ring of the filter cover (2) for
damage. If necessary, replace the O-ring.
Grease the O-ring.
2.
Grease the O-ring of the new filter (3) and
place the filter on the filter cover.
3.
Then insert the filter and the filter cover into
the filter housing.
4.
Use a plastic mallet to tap the filter cover into
the filter housing.
5.
Tighten the attachment bolt (1) to the
specified tightening torque, see main group
"Technical data".
©
200423
4-19
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
4.13 REMOVAL AND INSTALLATION, AUTOMATIC GEARBOX OIL FILTERS
To prevent skin injury, avoid
unnecessary contact with the
drained oil.
Removing automatic gearbox oil filters
1.
Remove the attachment bolts from the filter
covers (2) and remove the filter covers.
Collect any oil that is flowing out.
2.
Remove the oil filters from the oil sump.
3.
Remove the various O-rings from the filter
covers.
4.
If a gasket is used, remove the any pieces of
the gasket left on the filter covers and the
contact surfaces.
Fitting automatic gearbox oil filters
1.
Lightly lubricate the new O-rings with clean
gearbox oil and fit the various O-rings to the
filter covers.
Note:
Compare the new O-rings to the old O-rings
to ensure that the correct O-rings are used.
2.
If a gasket is used, fit a new gasket to the
filter cover.
3.
Lightly lubricate the rubber inner ring of the
oil filters with clean gearbox oil and fit the oil
filters to the filter covers.
4.
Fit the filter covers together with the oil filters
to the gearbox and tighten the attachment
bolts to the specified torque, see main group
"Technical data".
5.
Check the oil level, see chapter "Inspection
and adjustment".
}
V300371
2
1
W 3 03 103
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-20
©
200423
Removal and installation
5
ΧΦ75 series
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст