DAF CF65, CF75, CF85 Series . Manual — part 1176
©
200423
7-1
Lubrication
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
7. LUBRICATION
7.1 LUBRICATE ACCORDING TO X-SERVICE LUBRICATION SCHEDULE
Lubrication
Check whether the lubricating points stated
below are applicable.
Note:
The lubricating points marked below with an (S)
indicate that the lubricating point is positioned on
both the left-hand and right-hand side of the
vehicle.
Lubricating stub axles (S)
1.
To make sure that the grease can penetrate
adequately, the stub axles should be
lubricated in unloaded condition. The front
axle should therefore be completely jacked
up.
2.
Lubricate the stub axles until grease comes
out.
G000189
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
7-2
©
200423
Lubrication
5
ΧΦ75 series
Lubricating the fifth wheel
Lubricating the air-sprung front axle (S)
Lubricating the leaf-sprung trailing axle (S)
G000192
G0 00 193
G000191
©
200423
7-3
Lubrication
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
Lubricating the leaf-sprung tandem axle (S)
Lubricating the trailer coupling
G000187
G000188
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
7-4
©
200423
Lubrication
5
ΧΦ75 series
Lubricating the rear axle brake camshaft (S)
(drum brake version)
Lubricating the drive shaft universal joint
1.
Grease the universal joints of the drive shaft
until the grease comes out of all 4 needle
bushes.
Note:
If the grease does not come out of all 4
needle bushes, the joint may be turned to
soften hardened grease.
If the grease does not come out of all 4
needle bushes after the drive shaft has been
repeatedly turned, the joint needs to be
replaced.
The maximum lubricating pressure should
not exceed 15 bar.
G000194
G0 00 267
V300899
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст