DAF CF65, CF75, CF85 Series . Manual — part 147
©
200346
4-9
Removal and installation
CAB TILTING MECHANISM
ΧΦ65/75/85 series
1
6
4.4 REMOVAL AND INSTALLATION, CAB TILTING PUMP TWO-WAY VALVE
Note:
-
Use a repair kit to replace the two-way valve.
-
Disassembling any other parts of the tilting
pump than those described in this chapter is
not permitted. A defective cab tilting
mechanism is often the result of incorrect
disassembly and/or assembly of the cab
tilting pump.
-
Clean the outside of the cab tilting pump.
-
Work in a clean environment.
Removing cab tilting pump two-way valve
1.
Remove the cab tilting pump.
2.
Tap the notched pin out of the two-way valve
and remove the steel ring. Remove the O-
ring from the steel ring.
3.
Secure the pump housing in a vice as shown
in the adjacent figure and carefully tap the
two-way valve with the sealing plug out of the
housing. Note: Mark the position of the two-
way valve in the pump housing so that the
new two-way valve can be mounted in the
right position.
K1 01 340
K1 01 496
CAB TILTING MECHANISM
4-10
©
200346
Removal and installation
6
ΧΦ65/75/85 series
1
4.
Take the pump housing from the vice and
remove the inlet ball.
5.
Remove the O-ring and the Teflon ring from
the pump housing.
Installing cab tilting pump two-way valve
Note:
-
When the two-way valve is installed, observe
the correct position of the openings in
relation to the connections.
-
After assembly of the two-way valve, the
pressure limiting valve must be checked/
adjusted. See "Inspection and adjustment".
1.
Fit the new inlet ball into the pump housing.
2.
Apply a little oil to the O-rings of the new two-
way valve only.
3.
Fit the two-way valve and the sealing plug in
the housing. Note: Make sure the openings
in the two-way valve and the connections in
the pump housing are well positioned.
4.
Fit the new O-ring and the Teflon ring in the
pump housing.
K1 01 497
k100144
©
200346
4-11
Removal and installation
CAB TILTING MECHANISM
ΧΦ65/75/85 series
1
6
5.
Fit the new O-ring in the steel ring. Fit the
steel ring onto the two-way valve and tap the
new notched pin into the two-way valve.
K1 01 340
CAB TILTING MECHANISM
4-12
©
200346
Removal and installation
6
ΧΦ65/75/85 series
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст