DAF CF65, CF75, CF85 Series . Manual — part 110
©
200346
4-39
Removal and installation
INTERNAL CAB COMPONENTS
ΧΦ65/75/85 series
1
2
5.
Raise the glass, tilt the window inwards and
remove it from the door.
Installing drop glass
1.
Position the drop glass in the door.
2.
Secure the drop glass to the window
mechanism, using the attachment bolts (2).
K1 00 612
K1 00 612
2
K1 00 907
INTERNAL CAB COMPONENTS
4-40
©
200346
Removal and installation
2
ΧΦ65/75/85 series
1
3.
Fit the squeegee strips.
4.
Position the window guide rail and the
attachment bolt (1).
5.
Close the glass almost completely. Check
whether the top edge of the drop glass is
parallel to the window frame. Loosen the
attachment bolts (2), if necessary. Move the
glass to the correct position and re-tighten
the attachment bolts (2).
6.
Use tape to attach the foil at (A).
7.
Install the door panel.
B
A
1
K1 00 642
©
200346
4-41
Removal and installation
INTERNAL CAB COMPONENTS
ΧΦ65/75/85 series
1
2
4.28 REMOVAL AND INSTALLATION, ENGINE BRAKE SWITCH
Removing engine brake switch
1.
Remove the cover in the door strut.
2.
Put the floor mat to one side.
3.
In the RHD version, remove the storage tray
from the engine tunnel and the lower
dashboard panel with the cigarette lighter.
4.
Remove the attachment bolts (1) from the
mounting plate and remove the mounting
plate with the engine brake switch.
5.
Remove the lock nut from the engine brake
switch and remove the switch.
Installing engine brake switch
1.
Fit the engine brake switch in the mounting
plate and fix it in place with the lock nut.
2.
Fit the mounting plate and apply locking
compound to the attachment bolts (1) and
tighten them to the specified torque. See
"Technical data".
3.
Fit the dashboard panel and the storage tray
on the engine tunnel.
4.
Reposition the floor mat.
5.
If applicable, fit the cover in the door strut.
K1 00 933
1
INTERNAL CAB COMPONENTS
4-42
©
200346
Removal and installation
2
ΧΦ65/75/85 series
1
4.29 REMOVAL AND INSTALLATION, FLOOR PLATE ON CO-DRIVER SIDE
}
Remove the earth lead from the
battery terminal; the steel floor plate
may cause a short circuit.
Removing floor plate on co-driver side
1.
Remove the cover in the door strut.
2.
Put the floor mat to one side.
3.
Remove the attachment bolts (1) from the
floor plate and remove it.
Installing floor plate on co-driver side
1.
Fit the floor plate and secure it using the
attachment bolts.
2.
Reposition the floor mat.
3.
Fit the cover in the door strut.
K1 00 935
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст