Honda Civic. Manual — part 410
Fig. 21: Removing Passenger's Vent
3. Install the passenger's vents in the reverse order of removal.
GLOVE BOX STRIKER REPLACEMENT
SRS components are located in this area. Review the SRS component locations, 2-
door (see ), 4-door (see COMPONENT LOCATION INDEX ) and the
precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before
doing repairs or service.
1. While holding the glove box, release the glove box stop on each side from the
NOTE:
Take care not to scratch the dashboard and related parts.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Dashboard - Civic (All Except Hybrid)
dashboard by pushing them inside (see step 1 in PASSENGER'S VENT ).
2. Remove the screws, then remove the glove box striker (A).
Fig. 22: Removing Glove Box Striker
3. Install the striker in the reverse order of removal.
DASHBOARD SIDE TRIM REMOVAL/INSTALLATION
1. Remove the dashboard side trim (A).
1 Gently pull up the rear edge to release the rear hooks (B).
2 Pull the trim away to release the front hook (C) from the A-pillar trim
(D).
NOTE:
Take care not to scratch the dashboard and related parts.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Dashboard - Civic (All Except Hybrid)
Fig. 23: Removing Dashboard Side Trim
2. Install the side trim in the reverse order of removal.
SIDE DEFOGGER VENT TRIM REMOVAL/INSTALLATION
1. Insert the trim tool into a gap between the side defogger vent trim (A) and the
dashboard (B), and release the hook (C).
Fig. 24: Removing Side Defogger Vent Trim
2. Install the side defogger vent trim in the reverse order of removal.
DASHBOARD/STEERING HANGER BEAM REMOVAL/INSTALLATION
Special Tools Required
NOTE:
Take care not to scratch the dashboard and related parts.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Dashboard - Civic (All Except Hybrid)
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program; call 888-
424-6857
SRS components are located in this area. Review the SRS component locations (see
COMPONENT LOCATION INDEX ) and the precautions and procedures (see
PRECAUTIONS AND PROCEDURES ) before doing repairs or service.
1. Make sure you have the anti-theft code for the audio or the navigation system,
then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes
before beginning work.
3. Remove these items:
Driver's dashboard lower cover (see DRIVER'S DASHBOARD
LOWER COVER REMOVAL/INSTALLATION )
Driver's dashboard undercover (see DRIVER'S DASHBOARD
UNDERCOVER REMOVAL/INSTALLATION )
Passenger's dashboard undercover (see PASSENGER'S DASHBOARD
UNDERCOVER REMOVAL/INSTALLATION )
Center console (see CENTER CONSOLE
REMOVAL/INSTALLATION )
Glove box (see GLOVE BOX REMOVAL/INSTALLATION )
Kick panel, both sides:
2-door (see DOOR SILL AREA - 2-DOOR )
NOTE:
Use the appropriate tool from the KTC trim tool set to
avoid damage when prying components.
Have an assistant help you when removing and
installing the dashboard/steering hanger beam.
Take care not to scratch the dashboard, body and other
related parts.
Put on gloves to protect your hands.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Dashboard - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст