Honda Civic. Manual — part 631
There should be continuity when the brake pedal is pressed.
There should be no continuity when the brake pedal is released.
3. Check for continuity between the No. 3 and No. 4 terminals (with cruise
control).
There should be no continuity when the brake pedal is pressed.
There should be continuity when the brake pedal is released.
4. If necessary, adjust or replace the switch, or adjust the pedal height (see
BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH
ADJUSTMENT ).
2008 Honda Civic LX
2006-08 ACCESSORIES & EQUIPMENT Exterior Lights - Civic (All Except Hybrid)
2006-08 ACCESSORIES AND EQUIPMENT
Exterior Trim - Civic GX
EMBLEM/STICKER REPLACEMENT
1. Clean the body surface with a sponge dampened in alcohol. After cleaning,
keep oil, grease, and water from getting on the surface.
2. Apply the stickers where shown:
When installing the AT-PZEV sticker on the inside surface of the left rear
door quarter glass, align the sticker with the edge of the glass mark as
shown, then press the sticker into place, and remove the application tape.
When installing the side NGV stickers on both rear doors, align the
application tape with the edges of the rear door and rear door molding as
shown, then press the sticker into place, and remove the application tape.
When installing the CNG sticker on the trunk lid, align the application
tape with the edge of the trunk lid as shown, then press the sticker into
place, and remove the application tape.
NOTE:
When removing the stickers, take care not to scratch the
body.
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Exterior Trim - Civic GX
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Exterior Trim - Civic GX
Fig. 1: Identifying Front Emblem
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Exterior Trim - Civic GX
Fig. 2: Identifying Side NGV Sticker And Rear Door Molding
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Exterior Trim - Civic GX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст