Honda Civic. Manual — part 995
OXYGEN SENSOR WARNING LIGHT
1994-95 PASSPORT (DX MODEL)
1. Heated Oxygen Sensor (HO2S) must be replaced every 90,000 miles. When
odometer reaches 90,000 miles, O2S indicator light on dash will illuminate,
and then every subsequent 90,000 miles. After servicing, turn off or reset
warning light.
2. To reset warning light, remove instrument cluster. Remove masking tape from
hole "B". See Fig. 6 or Fig. 7 . Remove screw from hole "A" and insert into
hole "B". Apply new masking tape to hole "A".
Fig. 6: Identifying Oxygen Sensor Warning Light Reset Holes (2.6L)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
NOTE:
Reset procedure is for first 90,000 mile reset. At every
subsequent 90,000 mile reset, move screw back to
previous hole.
2008 Honda Civic EX
GENERAL INFORMATION Service Reminder Indicators - Honda
Fig. 7: Identifying Oxygen Sensor Warning Light Reset Holes (3.2L)
Courtesy of ISUZU MOTOR CO.
TIRE PRESSURE MONITOR SYSTEM
2005-08 ODYSSEY
NOTE:
If a flat tire is replaced with the spare tire, and the flat tire is
stored in the cargo area, the low pressure indicator will stay
on but the appropriate tire indicator will go off. This
prevents the customer from thinking there is a problem with
the spare tire. When the flat tire is taken out of the vehicle
for repair, the TPMS indicator will come on because the
system is no longer receiving the signal from the tire's
transmitter.
NOTE:
When a tire pressure sensor is replaced or tires are rotated,
the sensor ID must be memorized by the TPMS control unit.
See TIRE PRESSURE SENSOR REGISTRATION in
appropriate manufacturer service information.
2008 Honda Civic EX
GENERAL INFORMATION Service Reminder Indicators - Honda
1. To put the gauge control module into the self-diagnostic mode, perform the
following:
Turn the headlight switch to ON.
Press and hold the SELECT/RESET (Instrument panel brightness) knob.
Turn the ignition switch to ON (II).
Within 5 seconds, turn the headlights to AUTO, then to ON, and then to
AUTO again.
Within 5 seconds, release the SELECT/RESET knob, then push and
release the knob three times.
2. Once the gauge control module is in the self-diagnostic mode, press and hold
the INFO button on the steering wheel for 5 seconds to get to the
CUSTOMIZE MENU.
3. Use the INFO button to scroll through to the PAX RESET screen, then press
the SEL/RESET button on the steering wheel.
4. Use the INFO button to scroll to the appropriate wheel, and then press the
SEL/RESET button on the steering wheel to reset the PAX warning system
display. The screen should read "PAX RESET COMPLETED". Repeat this
step for each wheel that needs to be reset.
5. Use the INFO button to scroll through to EXIT, then press the SEL/RESET
button.
6. Turn the ignition switch to OFF to exit the self-diagnostic mode.
2005-08 PILOT & RIDGELINE
NOTE:
On models equipped with PAX tire systems, if a tire is
repaired or replaced, the warning indicator (and the mileage
counter that supports it) must be reset, no matter how far
the vehicle was driven in the run flat mode.
NOTE:
If a flat tire is replaced with the spare tire, and the flat tire is
stored in the cargo area, the low pressure indicator will stay
on but the appropriate tire indicator will go off. This
prevents the customer from thinking there is a problem with
the spare tire. When the flat tire is taken out of the vehicle
2008 Honda Civic EX
GENERAL INFORMATION Service Reminder Indicators - Honda
2007-08 CR-V
2007-08 ELEMENT
for repair, the TPMS indicator will come on because the
system is no longer receiving the signal from the tire's
transmitter.
NOTE:
When a tire pressure sensor is replaced or tires are rotated,
the sensor ID must be memorized by the TPMS control unit.
See TIRE PRESSURE SENSOR REGISTRATION in
appropriate manufacturer service information.
NOTE:
On models equipped with PAX tire systems, if a tire is
repaired or replaced, the warning indicator (and the mileage
counter that supports it) must be reset, no matter how far
the vehicle was driven in the run flat mode. See appropriate
manufacturer service information.
NOTE:
If a flat tire is replaced with the spare tire, and the flat tire is
stored in the cargo area, the low pressure indicator will stay
on but the appropriate tire indicator will go off. This
prevents the customer from thinking there is a problem with
the spare tire. When the flat tire is taken out of the vehicle
for repair, the TPMS indicator will come on because the
system is no longer receiving the signal from the tire's
transmitter.
NOTE:
When a tire pressure sensor is replaced or tires are rotated,
the sensor ID must be memorized by the TPMS control unit.
See TIRE PRESSURE SENSOR REGISTRATION in
appropriate manufacturer service information.
NOTE:
If a flat tire is replaced with the spare tire, and the flat tire is
stored in the cargo area, the low pressure indicator will stay
on but the appropriate tire indicator will go off. This
2008 Honda Civic EX
GENERAL INFORMATION Service Reminder Indicators - Honda
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст