Honda Civic. Manual — part 949
Check the ECM/PCM DTCs. If there is no DTC, jump the SCS line with
the HDS, then disconnect the ECM/PCM connector A (44P), and the
moonroof control unit/motor 10P connector.
Make these input tests at the connector.
If any test indicates a problem, find and correct the cause, then
recheck the system.
If all the input tests prove OK, the control unit must be faulty; replace
the moonroof control unit/motor.
MOONROOF CONTROL UNIT INPUT TEST (2 OF 2)
7
LT
GRN
switch in TILT
position
No. 5 and No. 7
terminals: There
should be battery
voltage.
switch
An open in the
wire
8
YEL
[GRY]
Moonroof
switch in
CLOSE
position
Check for voltage
to ground at the
No. 5 and No. 8
terminals: There
should be battery
voltage.
Faulty moonroof
switch
An open in the
wire
9
LT
BLU
Moonroof
switch in OPEN
position
Check for voltage
to ground at the
No. 5 and No. 9
terminals: There
should be battery
voltage.
Faulty moonroof
switch
An open in the
wire
[ ] :2-door
Cavity Wire
Test
condition
Test: Desired result
Possible
cause if
result is not
obtained
Check for continuity
between the No. 4 terminal An open in
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Moonroof - Civic
MOONROOF SWITCH TEST/REPLACEMENT
06-07' MODELS
1. Remove the front individual map lights (see FRONT INDIVIDUAL MAP
LIGHT TEST/REPLACEMENT ).
2. Disconnect the moonroof switch 10P connector (A) and map light switch 3P
connector (B).
Fig. 5: Disconnecting Moonroof Switch 10P Connector And Map Light
Switch 3P Connector
3. Remove the moonroof switch (C).
4. Check for continuity between the terminals in each switch position according
to Fig. 6 .
4
BLU
Under all
conditions
and ECM/PCM connector A
(44P) No. 29 terminal: There
should be continuity.
the wire
Check for continuity
between the No. 4 terminal
and body ground: There
should be no continuity.
A short to
ground in the
wire
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Moonroof - Civic
Fig. 6: Identifying Moonroof Switch Continuity Table
5. If the continuity check is not as specified, replace the illumination bulb (D) or
the switch.
6. Install the switch and light in the reverse order of removal.
08' MODEL
1. Remove the front individual map lights (see FRONT INDIVIDUAL MAP
LIGHT TEST/REPLACEMENT ).
2. Disconnect the moonroof switch 10P connector (A) and map light switch 3P
connector (B).
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Moonroof - Civic
Fig. 7: Identifying Moonroof 12P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the moonroof switch (C).
4. Check for continuity between the terminals in each switch position according
to Fig. 6 .
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Moonroof - Civic
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст