Honda Civic. Manual — part 423

Fig. 40: Disconnecting Power Door Lock Actuator Connector

3. Pass the cables (C) and the harnesses (D) through the slits (E) in the plastic

cover (F), then remove them.

4. Carefully raise the glass (A) until you can see the bolts, then remove them.

Carefully pull the glass out through the window slot. Take care not to drop the
glass inside the door.

2008 Honda Civic LX

2006-08 ACCESSORIES & EQUIPMENT Doors - Civic (All Except Hybrid)

Fig. 41: Removing Front Door Glass (With Specifications)

5. Disconnect the connector (A), and detach the harness clip (B) from the

regulator (C).

2008 Honda Civic LX

2006-08 ACCESSORIES & EQUIPMENT Doors - Civic (All Except Hybrid)

Fig. 42: Disconnecting Connector And Detaching Harness Clip (With
Specifications)

6. Remove the bolts (D), and loosen the bolts (E), then remove the regulator

through the hole in the door.

7. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where

2008 Honda Civic LX

2006-08 ACCESSORIES & EQUIPMENT Doors - Civic (All Except Hybrid)

shown.

Fig. 43: Applying Multipurpose Grease To Sliding Surfaces

8. Install the glass and regulator in the reverse order of removal, and note these

items:

Roll the glass up and down to see if it moves freely without binding.

Make sure that there is no clearance between the glass and glass run
channel when the glass is closed.

Adjust the position of the glass as necessary (see FRONT AND REAR
DOOR GLASS ADJUSTMENT ).

Do the power window control unit reset procedure (see RESETTING
THE POWER WINDOW CONTROL UNIT ).

When reinstalling the door panel, make sure the plastic cover is installed

2008 Honda Civic LX

2006-08 ACCESSORIES & EQUIPMENT Doors - Civic (All Except Hybrid)