Honda Civic. Manual — part 401
Fig. 3: Identifying Cylinder Head Components (3 Of 3)
CYLINDER HEAD REMOVAL
NOTE:
Use fender covers to avoid damaging painted surfaces.
To avoid damage, unplug the wiring connectors
carefully while holding the connector portion.
To avoid damaging the cylinder head, wait until the
engine coolant temperature drops below 100 °F (38 ° C)
before loosening the cylinder head bolts.
Mark all wiring and hoses to avoid misconnection. Also,
2008 Honda Civic GX
2006-08 ENGINE Cylinder Head - Civic GX
1. Make sure you have anti-theft codes for the audio system and navigation
system (if equipped), then write down the audio presets.
2. Turn off the manual shut-off valve, (see ENGINE REMOVAL ).
3. To reduce pressure in the lines, start the engine, and run it until it stalls.
4. Disconnect the negative cable from the battery.
5. Drain the engine coolant, refer to the COOLANT REPLACEMENT .
6. Remove the drive belt, refer to the DRIVE BELT
REMOVAL/INSTALLATION .
7. Remove the intake manifold (see REMOVAL ).
8. Remove the harness clamps (A), and remove the positive crankcase ventilation
(PCV) hose from the clamp (B).
Fig. 4: Removing Harness Clamps
9. Remove the air cleaner housing bracket (A), then remove the harness holder
(B) from the cylinder head.
be sure that they do not contact other wiring or hoses,
or interfere with other parts.
2008 Honda Civic GX
2006-08 ENGINE Cylinder Head - Civic GX
Fig. 5: Identifying Air Cleaner Housing Bracket
10. Remove the upper radiator hose (A), heater hose (B), and water bypass hose
(C).
Fig. 6: Identifying Upper Radiator Hose, Heater Hose And Water Bypass
Hose
11. Remove the engine wire harness connectors and wire harness clamps from the
cylinder head.
Four fuel injector connectors
Engine coolant temperature (ECT) sensor 1 connector
Air fuel ratio (A/F) sensor connector
Secondary heated oxygen sensor (secondary HO2S) connector
Rocker arm oil control solenoid connector
2008 Honda Civic GX
2006-08 ENGINE Cylinder Head - Civic GX
Rocker arm oil pressure switch connector
12. Remove the four ignition coils, refer to the IGNITION COIL
REMOVAL/INSTALLATION .
13. Remove the three way catalytic converter (TWC) (see CATALYTIC
CONVERTER REMOVAL/INSTALLATION ).
14. Remove the thermostat housing, refer to the THERMOSTAT HOUSING
REMOVAL AND INSTALLATION .
15. Remove the cam chain, refer to the CAM CHAIN REMOVAL .
16. Remove the cylinder head bolts. To prevent warpage, unscrew the bolts, in
sequence, 1/3 of a turn at a time; repeat the sequence until all bolts are
loosened.
Fig. 7: Identifying Loosening Sequence Of Cylinder Head Bolts
17. Remove the cylinder head.
CAMSHAFT INSPECTION
1. Remove the camshaft sprocket, refer to the CAMSHAFT SPROCKET
REMOVAL AND INSTALLATION .
2. Remove the rocker arm assembly, refer to the ROCKER ARM ASSEMBLY
REMOVAL .
3. Put the rocker shaft holders on the cylinder head, then tighten the bolts, in
sequence, to the specified torque.
2008 Honda Civic GX
2006-08 ENGINE Cylinder Head - Civic GX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст