Honda Civic. Manual — part 298
Fig. 503: Setting Selector Control Shaft To N Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
28. Align the cutouts (A) on the rotary-frame with the neutral positioning cutouts
(B) on the transmission range switch (C), then put a 2.0 mm (0.08 in.) feeler
gauge blade (D) in the cutouts to hold the switch in the N position.
Fig. 504: Aligning Cutouts On Rotary-Frame With Neutral Positioning
Cutouts On Transmission Range Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
29. Install the transmission range switch (A) gently on the selector control shaft
(B) while holding it in the N position with the 2.0 mm (0.08 in.) blade (C).
NOTE:
Be sure to use a 2.0 mm (0.08 in.) blade or equivalent to
hold the switch in the N position.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Fig. 505: Holding N Position With Blade
Courtesy of AMERICAN HONDA MOTOR CO., INC.
30. Tighten the bolts on the transmission range switch while you continue to hold
it in the N position. Do not move the transmission range switch while
tightening the bolts. Remove the feeler gauge.
Fig. 506: Tightening Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
31. Install the harness clamp bracket (A) on the end cover (B).
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Fig. 507: Identifying Transmission Range Switch Cover, Harness Clamp
Bracket, Cover & Bolts w/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
32. Connect the transmission range switch connector (C) securely, then install the
harness clamps (D) on the clamp bracket.
33. Install the transmission range switch cover (E).
34. Install a new O-ring (A) on the input shaft (mainshaft) speed sensor (B), then
install the input shaft (mainshaft) speed sensor.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Fig. 508: Identifying Input Shaft (Mainshaft) Speed Sensor, O-Ring &
Bolts w/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
35. Install a new O-ring (C) on the output shaft (countershaft) speed sensor (D),
then install the output shaft (countershaft) speed sensor.
36. Install a new gasket (B) on the transmission housing, and install the ATF pipe
(C) and the ATF joint pipes (D).
Fig. 509: Identifying ATF Pipe, ATF Joint Pipes, Gasket, O-Ring & Bolts
w/Torque Specification
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст