Honda Civic. Manual — part 262
Fig. 311: Inserting Pin Into Hole On Shift Lever Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
12. Check that the shift lever is secured in R.
13. Install the shift cable end (A) over the mounting stud (B) by aligning its square
hole (C) with the square fitting (D) at the bottom of the stud. Do not install the
shift cable by holding the shift cable guide (E).
Fig. 312: Aligning Square Hole With Square Fitting
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
14. Check that the shift cable end (A) is properly installed on the mounting stud
(B).
Fig. 313: Identifying Shift Cable Properly And Improperly Installation
Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
15. If improperly installed, align the square fitting with the square hole by rotating
the mounting stud.
16. Install and tighten the nut.
Fig. 314: Identifying Shift Cable Nuts w/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
17. Remove the 6.0 mm (0.24 in.) pin that was installed to hold the shift lever.
18. Turn the ignition switch to ON (II). Move the shift lever to each position, and
check that the A/T gear position indicator follows the transmission range
switch.
19. Shift to P, and check that the shift lock works properly. Push the shift lock
release, and check that the shift lever releases.
20. Install the center console (see CENTER CONSOLE
REMOVAL/INSTALLATION ).
A/T GEAR POSITION INDICATOR
COMPONENT LOCATION INDEX
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Fig. 315: Identifying A/T Gear Position Indicator Component Location
Courtesy of AMERICAN HONDA MOTOR CO., INC.
CIRCUIT DIAGRAM
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст