Honda Civic. Manual — part 848
Fig. 132: Driving Oil Seal From Transmission Side
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Drive in the new ball bearing from the transmission side using the oil seal
driver (A).
Fig. 133: Driving Ball Bearing From Transmission Side
Courtesy of AMERICAN HONDA MOTOR CO., INC.
COUNTERSHAFT BEARING REPLACEMENT
Special Tools Required
Oil seal driver 07JAD-PL90100
Adjustable bearing puller, 20-40 mm 07736-A01000B
2008 Honda Civic LX
2006-08 TRANSMISSION Manual Transmission (SPFM) 5-Speed) - Civic
Slide hammer, 3/8"-16 UNF commercially available
1. Remove the needle bearing (A) using the 20-40 mm adjustable bearing puller
(B) and a commercially available 3/8"-16 UNF slide hammer (D), then remove
oil guide plate C.
Fig. 134: Removing Needle Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Position oil guide plate C and new needle bearing (A) in the bore of the clutch
housing (B).
Fig. 135: Installing Needle Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2008 Honda Civic LX
2006-08 TRANSMISSION Manual Transmission (SPFM) 5-Speed) - Civic
3. Install the needle bearing using the oil seal driver (D).
MAINSHAFT THRUST CLEARANCE ADJUSTMENT
Special Tools Required
Mainshaft holder 07GAJ-PG20110
Mainshaft base 07GAJ-PG20130
1. Remove the 52 x 62 mm shim (A) and oil guide plate M from the transmission
housing (B).
Fig. 136: Identifying Shim And Oil Guide Plate
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Thoroughly clean the 36 mm spring washer (A) and 26 mm washer (B) before
installing them on the clutch housing side ball bearing (C). Note the installation
direction of the spring washer.
2008 Honda Civic LX
2006-08 TRANSMISSION Manual Transmission (SPFM) 5-Speed) - Civic
Fig. 137: Identifying Spring Washer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the 3rd/4th synchro hub, the 4th/5th gear distance collar, the 5th synchro
hub, the MBS distance collar, and angular ball bearing on the mainshaft.
4. Install the mainshaft in the clutch housing.
5. Place the transmission housing over the mainshaft and onto the clutch housing.
6. Tighten the clutch and transmission housings with several 8 mm bolts.
7. Lightly tap on the mainshaft with a plastic hammer.
8. Attach the mainshaft holder (A) and mainshaft base (B) to the mainshaft as
follows:
Backout the mainshaft holder bolt (C), and loosen the two hex bolts (D).
Fit the holder over the mainshaft so its lip is toward the transmission.
Align the mainshaft holder lip around the groove at the inside of the
mainshaft splines, then tighten the hex bolts.
Fig. 138: Identifying Mainshaft Holder And Mainshaft Base
Courtesy of AMERICAN HONDA MOTOR CO., INC.
NOTE:
Refer to the MAINSHAFT REASSEMBLY EXPLODED
VIEW .
NOTE:
It is not necessary to use sealing agent between the
housings for this procedure.
2008 Honda Civic LX
2006-08 TRANSMISSION Manual Transmission (SPFM) 5-Speed) - Civic
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст