Honda Civic. Manual — part 285
8. Disassemble the installed parts from the secondary shaft.
SECONDARY SHAFT SEALING RING REPLACEMENT
The sealing rings are synthetic resin with chamfered ends. Check the condition of
the sealing rings, and replace them only if they are worn, distorted, or damaged.
1. For a better fit, squeeze sealing rings together slightly before installing them.
Fig. 424: Identifying Sealing Rings
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Apply ATF to new sealing rings, then install them on the mainshaft.
Fig. 425: Identifying Sealing Rings On Mainshaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. After installing the sealing rings, check the following:
The rings are fully seated in the groove.
The rings are not twisted.
The chamfered ends of the rings are properly joined.
CLUTCH DISASSEMBLY
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Special Tools Required
Clutch spring compressor attachment 07LAE-PX40100 or 07HAE-PL50101
Clutch spring compressor bolt assembly 07GAE-PG40200 or 07GAE-
PG4020A
1. Remove the snap ring using a screwdriver.
Fig. 426: Removing Snap Ring
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the clutch end-plate (A), the clutch discs (B) (6), the clutch wave-
plates (C) (6), and the waved spring (D) from the 1st clutch drum (E)
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Fig. 427: Identifying Clutch End-Plate, Clutch Discs, Clutch Wave-Plates,
Waved Spring And 1st Clutch Drum
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch flat-plates
(C) (4), and the waved spring (D) from the 2nd clutch drum (E).
Fig. 428: Disassembling 2nd Clutch Drum
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch flat-plates
(C) (4), and the waved spring (D) from the 4th clutch drum (E).
Fig. 429: Disassembling 4th Clutch Drum
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
5. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch wave-
plates (C) (4), and the waved spring (D) from the 3rd clutch drum (E).
Fig. 430: Disassembling 3rd Clutch Drum
Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch wave-
plates (C) (4), and the waved spring (D) from the 5th clutch drum (E).
Fig. 431: Disassembling 5th Clutch Drum
Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the clutch spring compressor attachment and the clutch spring
compressor bolt assembly.
2008 Honda Civic LX
2006-08 TRANSMISSION Automatic Transmission - Civic (Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст