Honda Civic. Manual — part 1050
Overrunning Clutch Inspection
14. While holding the drive gear (A), turn the gear shaft (B) counterclockwise.
Check that the drive gear comes out to the other end. If the drive gear does not
move smoothly, replace the gear cover assembly.
Fig. 30: Turning Gear Shaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
15. While holding the drive gear, turn the gear shaft clockwise. The gear shaft
should turn freely. If the gear shaft does not turn freely, replace the gear cover
assembly.
16. If the starter drive gear is worn or damaged, replace the overrunning clutch
assembly; the gear is not available separately.
Check the condition of the flywheel ring gear to see if the starter drive gear
teeth are damaged.
Starter Reassembly
17. Install the brush into the brush holder, and set the armature (A) in the brush
holder (B).
NOTE:
To seat the new brushes, slip a strip of # 500 or # 600
sandpaper, with the grit side up, between the
2008 Honda Civic GX
2006-08 ENGINE Starting System (K20Z3) - Civic (All Except Si)
Fig. 31: Identifying Brush Springs
Courtesy of AMERICAN HONDA MOTOR CO., INC.
18. While squeezing a spring (C), insert it in the hole on the brush holder, and push
it until it bottoms. Repeat this for the other three springs (D, E, and F).
19. Install the armature and brush holder assembly into the housing.
commutator and each brush, and smoothly turn the
armature. The contact surface of the brushes will be
sanded to the same contour as the commutator.
NOTE:
Make sure the armature stays in the holder.
2008 Honda Civic GX
2006-08 ENGINE Starting System (K20Z3) - Civic (All Except Si)
2006-08 ENGINE
Starting System (R18A1) - Civic (All Except Hybrid)
COMPONENT LOCATION INDEX
Fig. 1: Locating Starting System Components
2008 Honda Civic GX
2006-08 ENGINE Starting System (R18A1) - Civic (All Except Hybrid)
2008 Honda Civic GX
2006-08 ENGINE Starting System (R18A1) - Civic (All Except Hybrid)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
SYMPTOM TROUBLESHOOTING INDEX
SYMPTOM TROUBLESHOOTING INDEX (EXCEPT GX)
Symptom
Diagnostic procedure
Also check
for
Engine does not
start (does not
crank)
1. Check for loose battery terminals or
connections.
2. Test the battery for a low charge (see
BATTERY TEST ).
3. Check the starter (see STARTER
CIRCUIT TROUBLESHOOTING ).
4. Check the starter cut relay (see POWER
RELAY TEST ).
5. Check the transmission range switch
(A/T) (see TRANSMISSION RANGE
SWITCH TEST ).
6. Check the clutch interlock switch (M/T)
(see CLUTCH INTERLOCK SWITCH
TEST ).
7. Check the ignition switch or wire (see
IGNITION SWITCH (ALL EXCEPT
HYBRID) ).
Poor ground at
G101 (A/T) or
G401 (M/T)
Engine cranks,
but does not
1. Check for PGM-FI DTCs (see
GENERAL TROUBLESHOOTING
INFORMATION ).
2. Check the fuel pressure (see FUEL
PRESSURE TEST ).
3. Check for a plugged or damaged fuel line
(see FUEL LINE INSPECTION ).
4. Check for a plugged fuel filter (see FUEL
PRESSURE REGULATOR
Fuel level in
tank
2008 Honda Civic GX
2006-08 ENGINE Starting System (R18A1) - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст