Honda Civic. Manual — part 92
3. Check the connection at the OPDS sensor harness connectors (A) and the ODS
unit harness 18P connector (B).
Fig. 268: Identifying OPDS Sensor And ODS Unit Harness 18P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the connection OK?
YES -Go to step 4.
NO -Repair the poor connection, and clear the DTC.
4. Replace the OPDS sensor/seat-back foam (see FRONT SEAT-BACK
COVER REPLACEMENT ), and initialize the ODS unit (see ODS UNIT
INITIALIZATION).
5. Clear the DTC memory, then check for DTC 86-1x or 86-2x.
Is DTC 86-1x or 86-2x indicated?
YES -Replace the ODS unit (see ODS UNIT REPLACEMENT).
NO -The system is OK.
DTC 92-1X ("X" CAN BE 0 THRU 9 OR A THRU F): OPEN IN THE PASSENGER'S AIRBAG
CUTOFF INDICATOR
NOTE:
Before doing this troubleshooting procedure, review SRS
2008 Honda Civic EX
2006-08 RESTRAINTS SRS (Supplemental Restraint System) - Civic (Except Hybrid)
1. Clear the DTC memory (see CLEAR THE DTC MEMORY WITH THE
HDS).
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on
for about 6 seconds and then goes off.
Does the SRS indicator stay on, and is DTC 92-1x indicated?
YES -Go to step 3.
NO -Intermittent failure, system is OK at this time. Go to
TROUBLESHOOTING INTERMITTENT FAILURES. If another DTC is
indicated, troubleshoot the DTC.
3. Disconnect the passenger's airbag cutoff indicator 4P connector (see
PASSENGER'S AIRBAG CUTOFF INDICATOR ILLUMINATION
BULB TEST).
4. Turn the ignition switch OFF. Disconnect the negative cable from the battery,
then wait for 3 minutes.
5. Disconnect SRS unit connector A (28P) from the SRS unit (see step 8
DISCONNECTING SYSTEM CONNECTORS).
6. Reconnect the negative cable to the battery.
7. Turn the ignition switch ON (II).
8. Measure the voltage between the No. 13 terminal of SRS unit connector A
(28P) and body ground. There should be 0.5 V or less.
Precautions and Procedures (see PRECAUTIONS AND
PROCEDURES) and General Troubleshooting Information
(see GENERAL TROUBLESHOOTING INFORMATION).
2008 Honda Civic EX
2006-08 RESTRAINTS SRS (Supplemental Restraint System) - Civic (Except Hybrid)
Fig. 269: Measuring Voltage Between No. 13 Terminal Of SRS Unit
Connector A (28P) And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the voltage as specified?
YES -Faulty SRS unit or passenger's airbag cutoff indicator; replace the
passenger's airbag cutoff indicator. If the problem is still present, replace the
SRS unit (see SRS UNIT REPLACEMENT).
NO -Short to power in the dashboard wire harness; replace the dashboard wire
harness.
DTC 92-2X ("X" CAN BE 0 THRU 9 OR A THRU F): OPEN OR SHORT TO GROUND IN THE
PASSENGER'S AIRBAG CUTOFF INDICATOR
1. Clear the DTC memory (see CLEAR THE DTC MEMORY WITH THE
HDS).
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on
for about 6 seconds and then goes off.
Does the SRS indicator stay on, and DTC 92-2x indicated?
YES -Go to step 3.
NOTE:
Before doing this troubleshooting procedure, review SRS
Precautions and Procedures (see PRECAUTIONS AND
PROCEDURES) and General Troubleshooting Information
(see GENERAL TROUBLESHOOTING INFORMATION).
2008 Honda Civic EX
2006-08 RESTRAINTS SRS (Supplemental Restraint System) - Civic (Except Hybrid)
NO -Intermittent failure, system is OK at this time. Go to
TROUBLESHOOTING INTERMITTENT FAILURES. If another DTC is
indicated, troubleshoot the DTC.
3. Disconnect the passenger's airbag cutoff indicator 4P connector (see
PASSENGER'S AIRBAG CUTOFF INDICATOR ILLUMINATION
BULB TEST).
4. Turn the ignition switch OFF. Disconnect the negative cable from the battery,
then wait for 3 minutes.
5. Disconnect SRS unit connector A (28P) from the SRS unit (see step 8
DISCONNECTING SYSTEM CONNECTORS).
6. Measure the resistance between the No. 4 terminal of the passenger's airbag
cutoff indicator 4P connector and the No. 13 terminal of SRS unit connector A
(28P). There should be 0-1.0 ohms.
Fig. 270: Measuring Resistance Between No. 4 Terminal And No. 13
Terminal Of SRS Unit Connector A (28P)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is the resistance as specified?
YES -Go to step 7.
NO -Open in the dashboard wire harness; replace the dashboard wire harness.
7. Measure the resistance between the No. 13 terminal of the SRS unit connector
A (28P) and body ground. There should be an open circuit or at least 1 M
2008 Honda Civic EX
2006-08 RESTRAINTS SRS (Supplemental Restraint System) - Civic (Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст