Honda Civic. Manual — part 1105
5. Reconnect the connectors to the under-dash fuse/relay box, and make these
input tests at the connectors.
If any test indicates a problem, find and correct the cause, then recheck the
system.
If all the input tests prove OK, the MICU must be faulty; replace the
under-dash fuse/relay box.
MICU INPUT TEST (CONNECTORS RECONNECTED)
An open in the
wire
S6
(1)
BLU
Wiper/washer
switch (intermittent
dwell timer) turned
Check resistance
between S6 and S4
terminals: There
resistance should vary
from about 0 to 1
kohms.
Faulty
wiper/washer
switch
An open in the
wire
Short to ground
in the wire
(1)
USA EX model and Canada models
Cavity Wire
Test condition
Test: Desired result
Possible cause if
result is not
obtained
E6
BLK
Under all
conditions
Check for voltage to
ground: There should
be less than 0.5 V.
Poor ground
(G602)
An open in the
wire
T34 BLK
Under all
conditions
Check for voltage to
ground: There should
be less than 0.5 V.
Poor ground
(G501)
An open in the
wire
Ignition switch ON
Check for voltage
between S10 and S4
Faulty
wiper/washer
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Wipers/Washers - Civic (All Except Hybrid)
S10 ORN
(II), wiper/washer
switch (INT) ON
terminals, and S20 and
S4 terminals: There
should be less than 1
V.
switch
An open in the
wire
Ignition switch ON
(II), wiper/washer
switch OFF
Check for voltage
between S10 and S4
terminals, and S20 and
S4 terminals: There
should be 5 V or more.
Faulty
wiper/washer
switch
Short to ground
in the wire
S15 GRN
Ignition switch ON
(II), wiper/washer
switch (MIST) ON
Check for voltage
between S15 and S4
terminals: There
should be less than 1
V.
Faulty
wiper/washer
switch
An open in the
wire in the wire
Ignition switch ON
(II), wiper/washer
switch (MIST)
OFF
Check for voltage
between S15 and S4
terminals: There
should be 5 V or more.
Faulty
wiper/washer
switch
Short to ground
in the wire
S17
YEL
Ignition switch ON
(II), washer switch
ON
Check for voltage
between S17 and S4
terminals: There
should be less than 1
V.
Faulty
wiper/washer
switch
An open in the
wire
Ignition switch ON
(II), washer switch
OFF
Check for voltage
between S17 and S4
terminals: There
should be 5 V or more.
Faulty
wiper/washer
switch
Short to ground
in the wire
Ignition switch ON
(II), wiper/washer
Check for voltage
between S20 and S4
terminals: There
Faulty
wiper/washer
switch
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Wipers/Washers - Civic (All Except Hybrid)
WIPER/WASHER SWITCH TEST
1. Remove the wiper/washer switch (see WIPER/WASHER SWITCH
REPLACEMENT ).
2. Disconnect the dashboard wire harness 8P connector (A) from the
wiper/washer switch (B).
S20
WHT
switch (LOW) ON should be less than 1
V.
An open in the
wire
Ignition switch ON
(II), wiper/washer
switch OFF
Check for voltage
between S20 and S4
terminals: There
should be 5 V or more.
Faulty
wiper/washer
switch
Short to ground
in the wire
WHT
Ignition switch ON
(II), wiper/washer
switch (HIGH) ON
Check for voltage
between S20 and S4
terminals: There
should be less than 1
V.
Faulty
wiper/washer
switch
An open in the
wire
Ignition switch ON
(II), wiper/washer
switch OFF
Check for voltage
between S20 and S4
terminals: There
should be 5 V or more.
Faulty
wiper/washer
switch
Short to ground
in the wire
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Wipers/Washers - Civic (All Except Hybrid)
Fig. 10: Disconnecting Dashboard Wire Harness 8P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Check for continuity between the terminals in each switch position according
to Fig. 11 .
Fig. 11: Checking Continuity Between Wiper/Washer Switch Terminals
Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. If the continuity is not as specified, replace the switch.
WIPER MOTOR TEST
1. Remove the wiper arms.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Wipers/Washers - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст