Honda Civic. Manual — part 1002
5. Check for continuity between the 3P connector (male terminals) No. 1
terminals and the 2P connector (female terminals) No. 2 terminal, and the 3P
connector (male terminals) No. 2 and No. 3 terminals. There should be
continuity.
6. If the continuity check is not as specified, replace the appropriate seat heater.
FRONT PASSENGER'S SEAT
1. Remove the passenger's seat (see FRONT SEAT
REMOVAL/INSTALLATION ).
2. Disconnect the 3P connector (A) from the seat heater.
Fig. 8: Identifying Seat Heater Connectors (Passenger's Seat)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2008 Honda Civic EX
2008 ACCESSORIES & EQUIPMENT Seat Heaters - Civic (Except GX & Hybrid)
3. Check for continuity between the 3P connector (male terminals) No. 1 and No.
2 terminals. There should be continuity.
4. If the continuity is not as specified, replace the seat heater.
2008 Honda Civic EX
2008 ACCESSORIES & EQUIPMENT Seat Heaters - Civic (Except GX & Hybrid)
2006-08 ACCESSORIES AND EQUIPMENT
Seats - Civic GX
COMPONENT LOCATION INDEX
NOTE:
Refer to the SEATS (EXCEPT HYBRID) article for additional
information that is not shown in this article.
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Seats - Civic GX
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Seats - Civic GX
Fig. 1: Identifying Seats Component Location
REAR SEAT REMOVAL/INSTALLATION
1. Remove the bolt between the seat-back (A) and the seat cushion (B).
Fig. 2: Identifying Bolt Between Seat-Back And Seat Cushion
2. Pull each front edge of the seat cushion (A) up to release the hooks (B), then
pull back the seat cushion, and remove it.
Fig. 3: Pulling Front Edge Of Seat Cushion To Release Hooks
NOTE:
Take care not to scratch the body or tear the seat covers.
2008 Honda Civic EX
2006-08 ACCESSORIES AND EQUIPMENT Seats - Civic GX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст