Honda Ridgeline. Manual — part 209
11
12
13
14
14-221
C
D
B
A
A
B
C
D
30. Disconnect the input shaft (mainshaft) speed
sensor connector (A), the output shaft
(countershaft) speed sensor connector (B), the ATF
temperature sensor connector (C), and the 3rd
clutch transmission fluid pressure switch connector
(D).
31. Remove the transfer breather (A) from the throttle
cable bracket (B), and remove the transfer breather
hose clamp (C) from the heater hose (D).
32. Remove the connector bracket from the engine
front cylinder head; use the bracket bolt hole to
attach the engine hanger balancer bar front arm.
33. Remove the harness clamp bracket from the engine
rear cylinder head; use the bracket bolt hole to
attach the engine hanger balancer bar rear arm.
(cont’d)
40
41
16
17
14-222
Automatic Transmission
Transmission Removal (cont’d)
A
A
B
VSB02C000024
VSB02C000019
AAR-T-12566
A
C
B
34. Remove the service caps (A) for the front damper
flange nuts from the cowl cover (B). Position the
engine hanger adapters (VSB02C000024) with the
‘‘FRONT’’ mark facing forward over the damper
flange nuts.
35. Install the engine balance bar (VSB02C000019);
attach the front arm (A) to the front cylinder head
with a spacer and the 10 mm bolt, and attach the
rear arm (B) to the rear cylinder head with the
8 mm bolt.
36. Install the engine support hanger (AAR-T-12566) to
the vehicle, and attach the hook to slotted hold in
the engine balance bar. Tighten the wing nut (C) by
hand, and to lift and support the engine.
37. Remove the front mount nut.
38. Remove the front subframe stiffener.
18
19
20
21
14-223
A
B
A
B
C
D
F
G
E
H
K
J
I
A
B
C
B
C
A
39. Remove exhaust pipe A and its mount (B).
40. Remove the lock pins (A) and the castle nuts (B),
and separate the lower arms (C) from the knuckles
(D) (see page 18-12).
41. Insert a 6 mm Allen wrench (E) in the top of the ball
joint pin (F), and remove the nuts (G), then separate
the stabilizer link (H).
42. Remove the cotter pins (I) and nuts (J), and
separate the tie-rod end ball joints (K) from the
knuckles (see step 9 on page 18-15).
43. Remove the bolt securing the transfer breather
hose bracket (A), and disconnect the breather hose
(B) from the breather pipe (C) on the transfer
assembly.
44. Make a reference mark (A) across the propeller
shaft (B) and the transfer companion flange (C).
45. Separate the propeller shaft from the transfer
companion flange.
(cont’d)
22
23
24
25
14-224
Automatic Transmission
Transmission Removal (cont’d)
B
A
A
B
C
46. Remove the transfer assembly from the
transmission.
47. Remove the torque converter cover (A), and
remove the drive plate bolts (B) (8) while rotating
the crankshaft pulley.
48. Disconnect the power steering pressure switch
connector.
49. Remove the power steering fluid hose (A) from the
hose clamp (B) at the right front of the subframe.
50. Loosen the hose clamp bolt, then disconnect the
power steering fluid hose from the fluid line (C).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст