Honda Ridgeline. Manual — part 389
02
Front Subframe Alignment
’06 model
20-194
Frame
Subframe Replacement (cont’d)
SCREWDRIVER or
TAPERED PUNCH
INSTALLATION
REFERENCE HOLE
(Subframe side)
REFERENCE HOLE
(Body side)
SUBFRAME
FRONT SUBFRAME
To body
To body
To body
To body
To body
To body
To body
To body
FRONT SUBFRAME
FRONT BRACKET
FRONT SUBFRAME
REAR BRACKET
INSTALLATION
REFERENCE HOLE
INSTALLATION
REFERENCE HOLE
BODY
forward
Reference holes alignment
NOTE:
• Before removing the subframe, make a mark where the subframe lines up with the body for reinstallation.
• When installing, align both installation reference holes in the subframe with the reference holes in the body using a
screwdriver or tapered punch as a guide.
• After mounting the subframe and brackets loosely, align the reference marks with the body, then tighten the bolts.
• After reinstalling all removed parts, check and adjust the front wheel alignment (see page 18-5).
Make alignment
mark here.
Make alignment
mark here.
02
’07-08 models
20-195
SCREWDRIVER or
TAPERED PUNCH
INSTALLATION
REFERENCE HOLE
(Subframe side)
REFERENCE HOLE
(Body side)
SUBFRAME
FRONT SUBFRAME
To body
To body
To body
To body
To body
To body
To body
To body
FRONT SUBFRAME
FRONT BRACKET
FRONT SUBFRAME
REAR BRACKET
INSTALLATION
REFERENCE HOLE
INSTALLATION
REFERENCE HOLE
BODY
forward
Reference holes alignment
(cont’d)
Make alignment
mark here.
Make alignment
mark here.
03
Rear Subframe Torque
20-196
Frame
Subframe Replacement (cont’d)
REAR SUBFRAME
Reference hole alignment
SUBFRAME
REFERENCE HOLE
(Body side)
INSTALLATION
REFERENCE HOLE
(Subframe side)
SCREWDRIVER or
TAPERED PUNCH
UPPER INSULATOR
To body
To body
To
body
To body
LOWER INSULATOR
Forward
Forward
INSTALLATION
REFERENCE HOLE
WASHER
SPECIAL BOLT
14 x 1.5 mm
93 N·m (9.5 kgf·m, 69 lbf·ft)
SPECIAL BOLTS
14 x 1.5 mm
93 N·m (9.5 kgf·m, 69 lbf·ft)
WASHER
LOWER INSULATOR
UPPER INSULATOR
REAR SUBFRAME
SPECIAL BOLT
14 x 1.5 mm
93 N·m (9.5 kgf·m, 69 lbf·ft)
INSTALLATION
REFERENCE HOLE
NOTE:
• When installing, align both installation reference holes in the subframe with the reference holes in the body using a
screwdriver or tapered punch as a guide.
• After removing the subframe mounting bolts, be sure to replace them with new ones.
Replace.
Replace.
Replace.
SJC8A000000000J2001ZAAT01
20-197
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст