Honda Ridgeline. Manual — part 304
02
SJC8A00B44100019102MEAT00
Exploded View
18-41
Damper/Spring Disassembly, Inspection, and Reassembly
SELF-LOCKING NUT
10 x 1.25 mm
29 N·m (3.0 kgf·m, 22 lbf·ft)
DAMPER MOUNTING WASHER
DAMPER MOUNTING COLLAR
RUBBER BUSHING
DAMPER MOUNTING BASE
RUBBER BUSHING
DUST COVER
SPRING MOUNTING
CUSHION
DAMPER SPRING
DAMPER UNIT
BUMP STOP PLATE
BUMP STOP
LOWER SEAT COVER
(cont’d)
Replace.
Check for bending and damage.
Check for weakness and damage.
Check for deformation.
Check for weakness and damage.
Check for bending
and damage.
Check for deterioration
and damage.
Check for weakened
compression and damage.
Check for oil leaks,
gas leaks, and
smooth operation.
Check for weakness
and damage.
03
04
Disassembly
Inspection
18-42
Rear Suspension
Damper/Spring Disassembly, Inspection, and Reassembly (cont’d)
A
10 x 1.25 mm
B
NOTE: When compressing the damper spring, use a
commercially available strut spring compressor
(Branick MST-580A or Model 7200, or equivalent)
according to the manufacturer’s instructions.
1. Compress the damper spring, then remove the
self-locking nut (A) while holding the damper shaft
with a hex wrench (B). Do not compress the spring
more than necessary to remove the nut.
2. Release the pressure from the strut spring
compressor, then disassemble the damper as
shown in the Exploded View.
1. Reassemble all the parts, except for the dust cover,
the bump stop, the spring mounting cushion, and
the spring.
2. Compress the damper assembly by hand, and
check for smooth operation through a full stroke,
both compression and extension. The damper
should extend smoothly and constantly when
compression is released. If it does not, the gas is
leaking and the damper should be replaced.
3. Check for oil leaks, abnormal noises, and binding
during these tests.
05
01
07
±
±
Reassembly
18-43
A
B
C
FRONT
FRONT
10 °
3 °
10 °
3 °
D
D
Left:
Right:
B
10 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
C
A
1. Compress the damper spring.
2. Install all parts except the damper mounting
washer and self-locking nut onto the damper unit
(A) by referring to the Exploded View.
3. Align the bottom of the spring (B) and the stepped
part of the lower spring seat (C), and align the
damper mounting base (D) as shown.
4. Install the damper mounting washer (A) and
loosely install a new self-locking nut (B).
5. Hold the damper shaft using a hex wrench (C), and
tighten the self-locking nut to the specified torque
value.
SJC8A000000000J1801ZAAT03
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст