Honda Ridgeline. Manual — part 275
07
08
16-26
Driveline/Axle
Rear Driveshaft Removal (cont’d)
A
B
07AAD-S9VA000
11. Using the special tool, pry out the inboard joint (A)
from the differential (B).
NOTE: This is a prying tool; do not strike it with a
hammer.
12. Remove the rear driveshaft.
NOTE: When removing the outboard joint, the
knuckle is supported with a floor jack. Make sure
not to over extend the brake hose.
01
02
03
04
SJC8A00E16266500000LCAT00
Special Tools Required
Locking tab type
Double loop type
Inboard Joint Side
16-27
Rear Driveshaft Disassembly
A
B
D
C
E
E
D
B
C
A
F
A
C
D
B
E
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
1. Remove the boot bands. Be careful not to damage
the boot.
• If the boot band is a locking tab type (A), pry up
the locking tab (B) with a screwdriver, and lift up
the end of the band.
• If the boot band is a double loop type (C), lift up
the band end (D), and push it into the clip (E).
2. Remove the circlip (A).
3. Make a mark (B) on the bearing retainer (C) and
inboard joint (D) to identify the locations of ball
bearings and grooves in the inboard joint. Then
remove the inboard joint on the shop towel (E). Be
careful not to drop the ball bearings when
separating them from the inboard joint.
4. Remove the snap ring (A).
5. Make a mark (B) on the bearing retainer (C), the
bearing race (D), and driveshaft (E) to identify the
position of the bearing retainer and the bearing
race on the shaft.
6. Remove the bearing race and the steel ball
bearings (F).
(cont’d)
05
06
07
Outboard Joint Side
Locking tab type
Double loop type
16-28
Driveline/Axle
Rear Driveshaft Disassembly (cont’d)
A
B
C
D
A
B
D
C
E
7. Wrap the splines on the driveshaft (A) with vinyl
tape (B) to prevent damage to the boot.
8. Remove the inboard boot (C) and locking tab type
boot band (D). Be careful not to damage the boot.
9. Remove the vinyl tape.
1. Remove the boot bands. Be careful not to damage
the boot.
• If the boot band is a locking tab type (A), pry up
the locking tab (B) with a screwdriver, and lift up
the end of the band.
• If the boot band is a double loop type (C), lift up
the band end (D), and push it into the clip (E).
08
09
10
11
16-29
A
B
A
C
07XAC-001020A
B
A
2. Slide the outboard boot (A) to the inboard joint side.
Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and
the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same
position of the outboard joint end (C).
5. Carefully clamp the driveshaft in a vise.
6. Remove the outboard joint (A) using the special
tool and a commercially available 5/8’’ x 18 UNF
slide hammer (B).
7. Remove the driveshaft from the vise.
8. Remove the circlip from the driveshaft.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст