Honda Ridgeline. Manual — part 223
04
05
06
07
14-277
A
B
A
B
C
10. Remove the D3 switch harness terminals by prying
the lock tabs up with a thin blade screwdriver.
11. Pull the D3 switch harness wires (A) from shift lever
bracket side, and remove the harness wires. Leave
the harness tube (B) and remove only the wires.
12. Remove the shift lever knob from the shift lever.
13. Install a new shift lever knob on the shift lever.
14. Insert the new D3 switch harness wires (A) in the
original harness tube (B), then tie a string (C)
around the tube to secure the terminals in the tube.
(cont’d)
08
09
10
11
14-278
A/T Gear Position Indicator
D3 Switch Test/Replacement (cont’d)
A
B
C
A
B
C
D
E
E
15. Pull the old tube out of the shift lever knob side to
install the D3 switch harness wires.
16. Remove the old harness tube from the D3 switch
harness terminals.
17. Install the D3 switch harness terminals in the new
D3 switch. Either harness terminal can be installed
in either cavity.
18. Install the D3 switch (A) in the shift lever knob (B).
19. Install the new shift lever knob ring (C).
20. Install the RED harness terminal (A) of the shift lock
solenoid in the No. 5 cavity, and the BLK harness
terminal (B) in the No. 6 cavity.
21. Install the D3 switch harness terminals (WHT) (C) in
the No. 3 and No. 4 cavities. Either D3 switch
harness terminal can be installed in the No. 3 and
No. 4 cavities.
22. Install the park pin switch harness terminals (BLK)
(D) in the No. 1 and No. 2 cavities. Either park pin
switch harness terminal can be installed in the
No. 1 and No. 2 cavities.
Terminal side of male terminals
12
13
14-279
B
A
C
A
B
C
D
E
B
23. Make sure that all six terminals lock securely, then
install the lock covers (E) securely in place.
24. Install the D3 switch harness (A) in the harness
clamp (B) at the mark (C).
25. Route the harnesses (A) through the guides (B).
26. Align the marks (C) on each harness, and tie the
harness together into bundle with a new harness
clamp (D) over the marks.
27. Tie the harness together into bundle with a new
harness clamp, then install the harness clamp (E)
on the shift lever bracket.
28. Install the shift lever assembly (see page 14-245).
29. Check that the D3 switch operates.
*01
SJC8A00E10436400000DAAT00
14-280
A/T Interlock System
Component Location Index
SHIFT LOCK SOLENOID
PARK PIN SWITCH
STEERING LOCK ASSEMBLY
KEY INTERLOCK SOLENOID
DATA LINK
CONNECTOR
(DLC)
Shift Lock System Circuit
Troubleshooting, page 14-282
Test, page 14-286
Replacement, page 14-287
Key Interlock System Circuit
Troubleshooting, page 14-285
Test, page 14-289
Replacement, page 14-290
Key Interlock System Circuit
Troubleshooting, page 14-285
Test, page 14-286
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст