Honda Element. Manual — part 295
Fig. 561: Identifying Final Driven Gear From Differential Carrier (2WD) With Torque
Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the final driven gear on the differential carrier in the direction shown.
3. Tighten the bolts to the specified torque in a crisscross pattern in two or more steps.
OIL SEAL REPLACEMENT
Special Tools Required
Driver 07749-0010000
Oil seal driver attachment 07947-SD90101
Oil seal driver attachment 07JAD-PH80101
1. Remove the oil seal from the transmission housing.
NOTE:
The illustration shows the 4WD transmission; the 2WD transmission is similar.
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Fig. 562: Tapping Oil Seal From Transmission Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the oil seal from the torque converter housing.
Fig. 563: Tapping Oil Seal From Torque Converter Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the new oil seal (A) in the transmission housing with the oil seal driver and attachment.
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Fig. 564: Installing Oil Seal In Transmission Housing With Oil Seal Driver
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the new oil seal (A) in the torque converter housing with the oil seal driver and attachment.
Fig. 565: Installing Oil Seal In Torque Converter Housing With Oil Seal Driver
Courtesy of AMERICAN HONDA MOTOR CO., INC.
CARRIER BEARING OUTER RACE REPLACEMENT
Special Tools Required
Driver 07749-0010000
Attachment, 78 x 90 mm 07GAD-SD40101
Attachment, 72 x 75 mm 07746-0010600
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
1. Remove the bearing outer race (A), 76.2 mm thrust washer (B), and 76 mm thrust shim (C) from the
transmission housing (D) by heating the housing to about 212°F (100°C) with heat gun (E). Do not heat
the housing in more than of 212°F (100°C).
Fig. 566: Heating Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the bearing outer race (A) and 80 mm thrust washer (B) from the torque converter housing (C).
NOTE:
The bearing and bearing outer race should be replaced as a set.
Replace the bearing with a new one whenever the outer race is replaced.
Do not use the thrust shim on the torque converter housing.
Adjust bearing preload after replacing the bearing and outer race.
Coat all parts with ATF during installation.
The illustration shows the 4WD transmission; the 2WD transmission is
similar.
NOTE:
Let the transmission housing cool to room temperature before installing
the bearing outer race.
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст