Honda Element. Manual — part 555
ERROR CODE LIST
Example Indication
Fig. 5: Identifying Odometer Display (Example Indication)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the word "Error 1" is indicated, there is a malfunction in the communication line between the gauge
control module and the fast-controller area network (F-CAN). Check for DTCs in the ECM/PCM and
troubleshoot any DTCs found. If no DTCs are found, go to indicated troubleshooting.
If the word "Error 2" is indicated, there is a malfunction in the UART communication line between the
gauge control module and the multiplex control unit. Go to the gauge control module input test and check
the No. 27 terminal. If the wire harness is OK, substitute a known-good gauge control module and
recheck.
If the word "Error 3" is indicated, there is a malfunction in the communication line between the gauge
control module and F-CAN and UART. Check for DTCs in the ECM/PCM and troubleshoot any DTCs
found.
ENDING THE SELF-DIAGNOSTIC FUNCTION
Turn the ignition switch OFF.
CIRCUIT DIAGRAM
Error code
Type of communication line(s) error
Error 1
F-CAN communication
Error 2
UART communication
Error 3
F-CAN and UART communication
NOTE:
If the vehicle speed exceeds 1.2 mph (2 km/h), the self-diagnostic function ends.
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Gauges - Element
Fig. 6: Gauges - Circuit Diagram (1 Of 6)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Gauges - Element
Fig. 7: Gauges - Circuit Diagram (2 Of 6)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Gauges - Element
Fig. 8: Gauges - Circuit Diagram (3 Of 6)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Gauges - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст