Honda Element. Manual — part 517
2007-08 SUSPENSION
Front Suspension - Element
KNUCKLE/HUB/WHEEL BEARING REPLACEMENT
EXPLODED VIEW
Fig. 1: Exploded View Of Knuckle/Hub/Wheel Bearing With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Special Tools Required
Ball joint thread protector, 12 mm 07AAF-SDAA100
Hub dis/assembly tool 07GAF-SD40100
Ball joint remover, 32 mm 07MAC-SL0A102
Ball joint remover, 28 mm 07MAC-SL0A202
Ball joint thread protector, 14 mm 071AF-S3VA000
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Attachment, 62 x 68 mm 07746-0010500
Driver 07749-0010000
Support base 07965-SD90100
KNUCKLE/HUB REPLACEMENT
1. Raise the front of the vehicle, and support it with safety stands in the proper locations (see LIFT AND
SUPPORT POINTS ).
2. Remove the wheel nuts and front wheel.
Fig. 2: Identifying Front Wheel With Wheel Nuts With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the brake hose bracket mounting bolt (A).
Fig. 3: Identifying Brake Hose Bracket Mounting Bolt With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the
knuckle. To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the
caliper assembly from the undercarriage. Do not twist the brake hose excessively.
5. Raise the stake (A), then remove the spindle nut (B).
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Fig. 4: Identifying Spindle Nut With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the brake disc (see FRONT BRAKE DISC REPLACEMENT ).
7. Check the front hub for damage and cracks.
8. Remove the flange bolt (A) and wheel sensor (B) from the knuckle. Do not disconnect the wheel sensor
connector.
Fig. 5: Identifying Wheel Sensor With Flange Bolt And Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
9. Remove the flange nut (A) while holding the joint pin (B) with a hex wrench (C), and disconnect the
stabilizer link (D) from the lower arm (E).
NOTE:
Use a new flange nut during reassembly.
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Fig. 6: Identifying Joint Pin Flange Nut With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
10. Remove the lock pin (A) from the knuckle ball joint, then remove the castle nut (B).
Fig. 7: Identifying Knuckle Ball Joint Lock With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
11. Disconnect the lower arm from the knuckle using the ball joint thread protector and ball joint remover
NOTE:
During installation, insert the lock pin as shown after tightening the new
nut.
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст