Honda Element. Manual — part 468
Fig. 45: Identifying Upper Radiator Hose And Heater Hoses
29. Check the quick connector (A) and set ring (B) for cracks or damage. If the connector and/or set ring are
cracked or damaged, replace the connector.
Fig. 46: Identifying Quick Connector And Set Ring
30. Make sure the set ring is in place inside the quick connector. If the set ring is off the connector, replace
the quick connector.
31. Replace the O-ring (C) in the quick connector.
32. Check the lock (D) for damage or deformation. If the lock is damaged or deformed, replace it. When
installing the new lock to the connector, push it straight down along the groove.
33. Clean the connecting surface of the thermostat cover (E), then apply clean engine coolant around the
connecting surface.
34. Push the lock (A) down, then push the quick connector (B) onto the thermostat cover until you hear it
click.
2007 Honda Element EX
2007-08 ENGINE Engine Assembly - Element
Fig. 47: Pushing Lock And Quick Connector
35. A/T model: Install the harness clamps (A), then install the engine wire harness bracket mount bolts (B).
Fig. 48: Identifying Harness Clamps And Engine Wire Harness Bracket Mount Bolts
36. A/T model: Install the automatic transmission fluid (ATF) cooler hoses (A) and ATF filter mounting bolt
(B).
2007 Honda Element EX
2007-08 ENGINE Engine Assembly - Element
Fig. 49: Identifying ATF Filter Mounting Bolt And Automatic Transmission Fluid (ATF) Cooler
Hoses
37. Install the power steering (P/S) pump.
Fig. 50: Identifying Power Steering (P/S) Pump Bolt (With Torque Specifications)
38. Install the P/S hose to the bracket on the cylinder head cover.
39. Install the receiver line to the clamps (A).
2007 Honda Element EX
2007-08 ENGINE Engine Assembly - Element
Fig. 51: Identifying Receiver Line To Clamps
40. Install the drive belt (see DRIVE BELT INSPECTION ).
41. M/T model: Install the shift cables (see step 26 in TRANSMISSION INSTALLATION ).
42. M/T model: Install the clutch slave cylinder and clutch line bracket mounting bolt (see step 25 in
TRANSMISSION INSTALLATION ).
43. Push the engine control module (ECM)/powertrain control module (PCM) connector through the
bulkhead, then install the grommet (A).
Fig. 52: Identifying Engine Control Module (ECM)/Powertrain Control Module (PCM) Connector
44. Install the harness clamps (B) and accelerator pedal position (APP) sensor connector (C).
45. Connect the ECM/PCM connectors (A) and ECM/PCM wire harness connector (B), then install the bolt
(C).
2007 Honda Element EX
2007-08 ENGINE Engine Assembly - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст