Honda Element. Manual — part 526
5. Select the ETCS TEST, then select the TP POSITION CHECK and follow the screen prompts.
6. Turn the ignition switch OFF.
7. Jump the SCS line with the HDS.
8. Remove the passenger's dashboard under cover (see GLOVE BOX REMOVAL/INSTALLATION ),
the passenger's kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ), and the
glove box (see GLOVE BOX REMOVAL/INSTALLATION ).
9. Cut the plastic cross brace in the glove box opening with diagonal cutters in the area shown, and discard
it.
Fig. 9: Cutting Plastic Cross Brace In Glove Box Opening
Courtesy of AMERICAN HONDA MOTOR CO., INC.
10. Remove the relays (A), then remove the bolts (B) and the glove box frame (C).
Fig. 10: Identifying Relays, Bolts And Glove Box Frame
NOTE:
If the TP POSITION CHECK indicates FAILED, continue this procedure.
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
Courtesy of AMERICAN HONDA MOTOR CO., INC.
11. Remove the gray 20P ECM/PCM wire harness connector (A) from the ECM/PCM mounting bracket.
Fig. 11: Identifying ECM/PCM And Wire Harness Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
12. Disconnect the ECM/PCM connectors (B).
13. Remove the ECM/PCM mounting bolt (C) and the bracket.
14. Remove the nuts (D), then remove the ECM/PCM (E).
15. Install the parts in the reverse order of removal.
16. Open the SCS line with the HDS.
17. Turn the ignition switch ON (II).
18. Manually input the VIN to the ECM/PCM with the HDS.
19. Update the ECM/PCM if it does not have the latest software.
20. Select the IMMOBI SYSTEM with the HDS.
21. Enter the immobilizer code using the ECM/PCM replacement procedure in the HDS; it allows you to start
the engine.
22. Reset the ECM/PCM with the HDS.
23. If the TP POSITION CHECK failed in step 5, clean the throttle body (see THROTTLE BODY
CLEANING ).
24. Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
NOTE:
DTC P0630 "VIN Not Programmed or Mismatch" may be stored because
the VIN has not been programmed into the ECM/PCM; ignore it, and
continue this procedure.
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
25. Do the crank (CKP) pattern learn procedure.
OBD STATUS
The OBD status shows the current system status of each DTC and all of the parameters. This function is used to
see if the repair was successfully completed. The results of diagnostic tests for the DTC are displayed as:
PASSED: The on board diagnosis is successfully finished.
FAILED: The on board diagnosis has finished but failed.
EXECUTING: The vehicle is in enable criteria conditions for the DTC and the on board diagnosis is
running.
NOT COMPLETED: The on board diagnosis was running but is out of the enable conditions of the DTC.
OUT OF CONDITION: The vehicle has stayed out of the enable conditions for the DTC.
DTC TROUBLESHOOTING INDEX
DTC TROUBLESHOOTING CHART
DTC (MIL indication
(1)
)
Two Drive Cycle
Detection
Detection Item
MIL
P0010 (56)
--
Variable Valve Timing
Control (VTC) Oil Control
Solenoid Valve
Malfunction
ON
P0011 (56)
o
Variable Valve Timing
Control (VTC) System
Malfunction
ON
P0101 (50)
o
Mass Air Flow (MAF)
Sensor Circuit
Range/Performance
Problem
ON
P0102 (50)
--
Mass Air Flow (MAF)
Sensor Circuit Low
Voltage
ON
P0103 (50)
--
Mass Air Flow (MAF)
Sensor Circuit High
Voltage
ON
P0107 (3)
--
Manifold Absolute
Pressure (MAP) Sensor
Circuit Low Voltage
ON
P0108 (3)
--
Manifold Absolute
Pressure (MAP) Sensor
Circuit High Voltage
ON
P0111 (10)
o
Intake Air Temperature
(IAT) Sensor Circuit
ON
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
Range/Performance
Problem
P0112 (10)
--
Intake Air Temperature
(IAT) Sensor Circuit Low
Voltage
ON
P0113 (10)
--
Intake Air Temperature
(IAT) Sensor Circuit High
Voltage
ON
P0116 (86)
o
Engine Coolant
Temperature (ECT) Sensor
1 Circuit
Range/Performance
Problem
ON
P0117 (6)
--
Engine Coolant
Temperature (ECT) Sensor
1 Circuit Low Voltage
ON
P0118 (6)
--
Engine Coolant
Temperature (ECT) Sensor
1 Circuit High Voltage
ON
P0122 (7)
--
Throttle Position (TP)
Sensor A Circuit Low
Voltage
ON
P0123 (7)
--
Throttle Position (TP)
Sensor A Circuit High
Voltage
ON
P0125 (86)
o
Engine Coolant
Temperature (ECT) Sensor
1 Malfunction/Slow
Response
ON
P0128 (87)
o
Cooling System
Malfunction
ON
P0133 (61)
o
Air Fuel Ratio (A/F)
Sensor (Sensor 1)
Malfunction/Slow
Response
ON
P0134 (41)
o
Air Fuel Ratio (A/F)
Sensor (Sensor 1) Heater
System Malfunction
ON
P0135 (41)
--
Air Fuel Ratio (A/F)
Sensor (Sensor 1) Heater
Circuit Malfunction
ON
P0137 (63)
o
Secondary Heated Oxygen
Sensor (Secondary HO2S
(Sensor 2)) Circuit Low
Voltage
ON
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст