Honda Element. Manual — part 523
lightly.
Fig. 41: Identifying Upper Spring Seat And Spring On Strut Spring Compressor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Insert the damper unit (B) up through the compressed spring.
6. Align the bottom of the spring (C) and the stepped part (D) of the lower spring seat.
7. Align an angle (A) of the ball joint connecting hole (B) on the steering arm and the cutout (C) on the
upper spring seat.
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Fig. 42: Aligning Angle Of Ball Joint Connecting Hole And Cutout
Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Turn the damper mounting base and L/R mark (D) faces toward the outside position, then align angle (E)
of the ball joint connecting hole and stud bolt (F).
9. Hold the bottom of the damper with your hand, and compress the spring. Do not compress the spring
excessively.
10. Install a new 12 mm self-locking nut (A) on the damper shaft (B).
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
Fig. 43: Identifying Self-Locking Nut On Damper Shaft With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
11. Hold the damper shaft with a hex wrench (C), and tighten the 12 mm self-locking nut to the specified
torque value.
12. Remove the damper assembly from the strut spring compressor.
2007 Honda Element EX
2007-08 SUSPENSION Front Suspension - Element
2007-2008 ENGINE PERFORMANCE
Fuel and Emissions Systems - Element
SPECIAL TOOLS
Fig. 1: Identifying Special Tools
Courtesy of AMERICAN HONDA MOTOR CO., INC.
GENERAL TROUBLESHOOTING INFORMATION
INTERMITTENT FAILURES
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
2007 Honda Element EX
2007-2008 ENGINE PERFORMANCE Fuel and Emissions Systems - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст