Honda Element. Manual — part 810
Fig. 4: Rear Window - Circuit Diagram
Courtesy of AMERICAN HONDA MOTOR CO., INC.
WIPER/WASHER SWITCH TEST/REPLACEMENT
1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Wipers/Washers - Element
REMOVAL/INSTALLATION ).
2. Remove the steering column covers (see STEERING COLUMN REMOVAL AND
INSTALLATION ).
3. Disconnect the 14P connector (A) from the wiper/washer switch (B).
Fig. 5: Identifying 14P Connector And Wiper/Washer Switch Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the two screws, then pull out the wiper/washer switch.
5. Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, check for continuity between the terminals in each switch position
according to the tables. If the continuity is not as specified, replace the switch.
Windshield
Fig. 6: Terminals Continuity Chart - Windshield
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Rear Window
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Wipers/Washers - Element
Fig. 7: Terminals Continuity Chart - Rear Window
Courtesy of AMERICAN HONDA MOTOR CO., INC.
CONTROL UNIT INPUT TEST
1. Before testing, troubleshoot the multiplex control system (see TROUBLESHOOTING ).
2. Remove the dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER
REMOVAL/INSTALLATION ).
3. Disconnect the under-dash fuse/relay box connectors B, F, G, J, X and Y.
Fig. 8: Identifying Under-Dash Fuse/Relay Box Connectors
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals are OK, go to step 5.
5. Reconnect the connectors, and make these input tests at the connector.
NOTE:
All connectors are shown from wire side of female terminals.
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Wipers/Washers - Element
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the multiplex control unit must be faulty; replace the under-dash
fuse/relay box assembly.
TEST CONDITION
Cavity
Wire
Test condition
Test: Desired result
Possible cause if desired
result is not obtained
J4
BLK
Under all conditions
Measure voltage to
ground: There should
be less than 0.5 V.
Poor ground(G401)
An open in the wire
Y6
BLK
Under all conditions
Measure voltage to
ground: There should
be less than 0.5 V.
Poor ground(G502)
An open in the wire
B1
WHT/GRN
Ignition switch ON (II)
and washer switch ON
Measure voltage to
ground: There should
be battery voltage.
Blown No. 20 (20 A)
fuse in the under-dash
fuse/relay box
Faulty wiper/washer
switch
An open in the wire
X7
BLU/BLK
Ignition switch ON (II)
and wiper switch in INT
Measure voltage to
ground: There should
be battery voltage.
B6
BLU/RED
Ignition switch ON (II),
wiper switch in OFF or
INT, and when the motor
is not in operation.
Measure voltage to
ground: There should
be battery voltage.
Blown No. 20 (20 A)
fuse in the under-dash
fuse/relay box
Faulty wiper/washer
switch
Faulty windshield
wiper motor
An open in the wire
G7
BLU/WHT
Ignition switch ON (II)
and wipers in park
position
Measure voltage to
ground: There should
be battery voltage.
Blown No. 20 (20 A)
fuse in the under-dash
fuse/relay box
Faulty windshield
wiper motor
An open in the wire
B1
F6
WHT/GRN
Jump B1 to F6 terminals,
then ignition switch ON
(II) and washer switch
ON
Check windshield
washer motor
operation: The washer
motor should run.
Poor ground(G201)
Blown No. 20 (20 A)
fuse in the under-dash
fuse/relay box
Faulty wiper/washer
switch
Faulty windshield
washer motor
Faulty under-dash
2007 Honda Element EX
2007-08 ACCESSORIES AND EQUIPMENT Wipers/Washers - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст