Honda Element. Manual — part 259
COMPONENT LOCATION INDEX
Fig. 328: Identifying A/T Gear Position Indicator Components Location
Courtesy of AMERICAN HONDA MOTOR CO., INC.
CIRCUIT DIAGRAM
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Fig. 329: A/T Gear Position Indicator - Circuit Diagram
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig. 330: Identifying PCM Connector Terminal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
D3 SWITCH CIRCUIT TROUBLESHOOTING
1. Turn the ignition switch ON (II).
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
2. Shift to the D position and select D3 driving mode by pressing the D3 switch, and watch the D3 indicator.
Does the D3 indicator come on?
YES -The system is OK at this time.
NO -Go to step 3.
3. Check the PGM-FI DTCs with the HDS.
Are DTC U0028 or U0155 indicated?
YES -Troubleshoot the indicated DTC, then recheck.
NO -Go to step 4.
4. Turn the ignition switch OFF.
5. Disconnect the D3 switch/shift lock solenoid connector.
6. Check for continuity between D3 switch/shift lock solenoid connector terminals No. 1 and No. 2 while
pressing the switch and when the switch is released.
Fig. 331: Checking Continuity Between D3 Switch/Shift Lock Solenoid Connector Terminals No. 1
And No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity while pressing the D3 switch, and no continuity when the D3 switch is released?
YES -Go to step 7.
NO -Replace the D3 switch (see D3 SWITCH TEST/REPLACEMENT ).
7. Turn the ignition switch ON (II).
8. Shift the shift lever to the D position.
9. Measure the voltage between D3 switch/shift lock solenoid connector terminals No. 1 and No. 2.
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Fig. 332: Measuring Voltage Between D3 Switch/Shift Lock Solenoid Connector Terminals No. 1
And No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -D3 switch circuit is OK. Check for loose terminals.
NO -Go to step 10.
10. Measure the voltage between D3 switch/shift lock solenoid connector terminal No. 1 and body ground.
Fig. 333: Measuring Voltage Between D3 Switch/Shift Lock Solenoid Connector Terminal No. 1
And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -Repair open in the wire between D3 switch/shift lock solenoid connector terminal No. 2 and
ground (G451), or repair poor ground (G451).
NO -Go to step 11.
11. Measure the voltage between PCM connector terminal D3 and body ground.
2007 Honda Element EX
2007-2008 TRANSMISSION Automatic Transmission - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст